• Home
• Brands
• Epson Manuals
• Epson PictureMate Express Edition - Compact Photo Printer
• Epson PictureMate Express Edition Quick Setup Instructions Manual

Epson PictureMate Express Edition Quick Setup Instructions Manual

Download Start here manual of Epson PictureMate Express Edition - Compact Photo Printer Desktop, Printer for Free or View it Online on All-Guides.com.

1

2

3

4

5

6

®

Start Here

Set up your PictureMate and

print–no computer required!

Note: To print from your computer, see Using PictureMate With a

Computer and your CD after completing these steps.

1 Unpack

PictureMate comes with all these items in the box.

Remove all the tape and packing material from PictureMate.

Caution: To avoid damaging your PictureMate,

keep it out of the sun and don’t leave it in your

car or other location where it can get too hot.

2 Install the Photo

Cartridge

1 Flip the handle up.

2 Open the cartridge door

on the back of PictureMate.

You see the release lever.

3 Move the lever to the Release position by sliding it

in the direction shown.

4 Shake the photo cartridge

a few times in its package,

then unwrap the cartridge.

5 Slide the cartridge straight into the slot, label side up,

until it is fully inserted. Push in both sides evenly to

make sure it is not crooked.

Caution: Make sure both sides of the cartridge are even,

or ink may leak. If either side is sticking out, remove the

cartridge and reinstall it.

6 Move the lever right to the Lock position. If it does

not lock in place, the cartridge is not installed

correctly. Release it and try again.

7 Close the cartridge door. Make sure it snaps shut.

If the door does not close completely, the cartridge is

not installed correctly. Remove it and try again.

8 Flip the handle to the

back of PictureMate

and all the way down.

3 Plug In and Turn

On PictureMate

1 Connect the power cable

to the power adapter.

2 Plug the small cable into

the back of PictureMate.

3 Plug the other end of

the power cable into a

standard power outlet.

4 Press the On button to turn on PictureMate.

PictureMate gets the ink ready for printing.

You see this message:

After a few minutes, when PictureMate is ready,

you see this message:

5 Press the OK button.

4 Load Paper

Your PictureMate comes with photo paper made especially

for it.

Caution: Don’t load or print on plain paper; this may damage

PictureMate.

1 Flip open the

paper support.

2 Pull up the paper

support all the way.

3 Open the output tray.

Note: Make sure the paper support is fully extended.

PictureMate

Power cable PictureMate Photo Cartridge

Paper

Using PictureMate

Without a Computer

booklet

Printer

Software

CD

+

Turn over

Using PictureMate

With a Computer

booklet

Power adapter

4051812-00 XXX

To release lever

Handle

Lever

Make sure the handle

is all the way down

WrongRight