EAW DSA230i Owner's Manual
Download Owner's manual of EAW DSA230i Portable Speakers, Speakers for Free or View it Online on All-Guides.com.
Brand: EAW
Category: Portable Speakers , Speakers
Type: Owner's manual
Model: EAW DSA230i , EAW DSA250i
Pages: 52 (2.38 Mb)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
2. Install at least one of the supplied 1/4-20 X 3 in Retainer Bolts with
its lock washer through the side of either the top or bottom
Wall/Enclosure Bracket and snugly tighten. The bolt threads into a weld
nut on the side of the Wall Bracket. This Retainer Bolt prevents the
enclosure from being lifted off the Wall Brackets without first removing
the bolt. Note that the Retainer Bolt does not “clamp” or support
anything. It serves only to retain the enclosure on the wall brackets, not
to lock it into position.
3. Route cabling as required using the rear
channels in the enclosure’s extrusion.
4. Rotate the enclosure to the desired
horizontal angle. Firmly tighten each
Enclosure Bracket Bolt to secure the
enclosure in the desired position.
5.7 Initial Set-Up
5.7.1 VERIFY MODULE ORIENTATION AND POSITION
Using DSAPilot and with communications established with the modules,
click on each module in DSAPilot. The LED in both the DSAPilot
graphic and on the actual module will illuminate. Ensure it is the correct
module and that its physical orientation, and, if applicable, its position
in a cluster corresponds to that shown in the DSAPilot graphic. See the
DSAPilot help file for further information.
CAUTION: Incorrect orientation or cluster position will result in poor to
unusable performance.
5.8 Acoustical Installation
Adjustment of the signal processing and thus the acoustical performance
for each DSAi Cluster is accomplished using the DSAPilot software.
Complete instructions for its use can be found in the DSAPilot Help file.
These are the basic tasks that need to be done using DSAPilot:
1. Select each cluster configuration used in the system design.
2. Assign the installed clusters to those selected in DSAPilot.
3. Set the Steering parameters for each cluster.
4. Configure the audio input routing for each cluster.
5..Set the user-adjustable gain, EQ, compression, or signal delay for
the inputs.
6. Set the desired Power Saving operation.
7. Save the final signal processing settings for the system to a file.
27
1/4-20 X 3 LG
HEX HEAD SCREW
& LOCK WASHER
1/4-20 WELD NUT
Figure 5.6.9b Retainer Bolt Installation
CABLE CHANNELS
Figure 5.6.9c Cable Routing
ENCLOSURE BRACKET BOLT
Figure 5.6.9d Secure the Enclosure Position
LED INDICATOR
Figure 5.7.1 Identification LED