EAW KF860 Tech Note

Download Tech note of EAW KF860 Accessory, Speaker System for Free or View it Online on All-Guides.com.

Brand: EAW

Category: Accessory , Speaker System

Type: Tech note for EAW KF860

Pages: 4 (0.21 Mb)

Download EAW KF860 Tech note

EAW KF860 Tech note - Page 1
1
EAW KF860 Tech note - Page 2
2
EAW KF860 Tech note - Page 3
3
EAW KF860 Tech note - Page 4
4
EASTERN ACOUSTIC WORKS
One Main Street, Whitinsville, MA 01588 • (508) 234 - 6158 • FAX (508) 234 - 8251 • Email [email protected] • Web http://www.eaw.com
EAW products are continually improved. All specifications are therefore subject to change without notice. • PUB# KF860 Tech Notes 999274 (A)/4p/12/28/97 • Printed In USA
PROCEDURE
1
Hang the Flybar on an appropriate and properly
installed chain motor or hoist. Always use a licensed
rigger to install the chain motor.
SAFETY
PINS
ADJUSTABLE
RIGGING PLATE
FLYBAR
PLUNGER
BALL STOP
2
Install Rigging Plates (angled edge forward) into the
slots on each end of the Flybar. Align each Plate’s
top front and 3rd-from-the-top rear holes with the
holes in the Flybar as shown. Fully insert two Safety
Pins per Rigging Plate. Position both Rigging Plates
an equal distance from the front of the Flybar. The
tilt angle of the array can be adjusted by positioning
the first Module forward or back on the Flybar.
To insert a Safety Pin into a hole, depress its rear
plunger so that the two Ball Stops will recess into
the pin body. Once it is fully inserted into the
Module’s End Bracket release the rear plunger, and
the ball stops will lock the Safety Pin into place. A
fully inserted Safety Pins will pass through the
Flybar/End Bracket’s outer rail, the Rigging Plate and
the Flybar/End Bracket’s inner rail.
LOAD RATING
Safe working load is 4000 lb./Module.
Calculated at 5:1 safety factor + pull tested.
Maximum column length is 10 Modules.
RIGGING HARDWARE TECH NOTE KF860
A
C
O
U
S
T
I
C
A
L
P
E
R
F
O
R
M
A
N
C
E
P
A
R
T
N
E
R
S
H
I
P