Xantech RS41AV Install Manual

Download Installation instructions of Xantech RS41AV Other for Free or View it Online on All-Guides.com.

Brand: Xantech

Category: Other

Type: Installation instructions for Xantech RS41AV

Pages: 4 (0.16 Mb)

Download Xantech RS41AV Installation instructions

Xantech RS41AV Installation instructions - Page 1
1
Xantech RS41AV Installation instructions - Page 2
2
Xantech RS41AV Installation instructions - Page 3
3
Xantech RS41AV Installation instructions - Page 4
4
1
Remote Control Switchers
GENERAL INFORMATION
The RS41AV is a low noise, wide bandwidth, unity gain, infrared remote controlled switcher for line level
stereo audio and video baseband signals.
It selects audio and video signals from any one of four sources and sends them to one output with no signal
loss.
It allows additional source selections for the inputs of A/V receivers, VCR's, TV monitors, etc.
A hand-held programmer, model RC68+ (available separately), is the source of the four IR input switching
commands for the RS41AV (see Fig.4). Normally the installer would "teach" these commands into a
Xantech Learning Remote, Key Pad or other learning device for eventual use by the customer.
The space saving "flat pack" design allows great flexibility in mounting and positioning.
INSTALLATION INSTRUCTIONS
RS41AV
FOUR INPUT AUDIO/VIDEO REMOTE SWITCHER
IR
CONFIRM
VVPOWER 15VAC
VIDEO
AUDIO
LEFT
INPUT
OUTPUT
AUDIO
RIGHT
1234
6
3
5
1
2 4
®
RS41AV
REMOTE SWITCHER
G IR IN
Fig. 1
RS41AV PANEL DESCRIPTIONS
1. INPUT jacks. Connect to the corresponding output jacks of the source components (satellite receiver,
VCR, camcorder, laser disc player, TV surveillance camera, CD player, AM/FM tuner, cassette tape
deck, etc.).
2. OUTPUT jacks. Connect to the corresponding input jacks of AV receivers, TV monitors, VCRs, etc.
3. POWER 15VAC V V terminals. Connect the leads of the 15V AC Power Supply (included) to these
terminals (lead polarity is not required).
4. G and IR IN terminals. Input terminals for the IR control signal. Connect a 2-conductor cable from
the emitter or signal output port of any Xantech Connecting Block, IR receiver, Key Pad, or Controller
here. The positive lead connects to "IR IN" and the negative to "G".
5. IR CONFIRM LED. Lights continuously when power is applied. Flashes when RC68+ (and RC68)
IR commands are received.
6. Mounting Holes.