Delta 31-340 Instruction Manual

Download Instruction manual of Delta 31-340 Sander for Free or View it Online on All-Guides.com.

Brand: Delta

Category: Sander

Type: Instruction manual for Delta 31-340

Pages: 18 (0.73 Mb)

Download Delta 31-340 Instruction manual

Delta 31-340 Instruction manual - Page 1
1
Delta 31-340 Instruction manual - Page 2
2
Delta 31-340 Instruction manual - Page 3
3
Delta 31-340 Instruction manual - Page 4
4
Delta 31-340 Instruction manual - Page 5
5
Delta 31-340 Instruction manual - Page 6
6
Delta 31-340 Instruction manual - Page 7
7
Delta 31-340 Instruction manual - Page 8
8
Delta 31-340 Instruction manual - Page 9
9
Delta 31-340 Instruction manual - Page 10
10
Delta 31-340 Instruction manual - Page 11
11
Delta 31-340 Instruction manual - Page 12
12
Delta 31-340 Instruction manual - Page 13
13
Delta 31-340 Instruction manual - Page 14
14
Delta 31-340 Instruction manual - Page 15
15
Delta 31-340 Instruction manual - Page 16
16
Delta 31-340 Instruction manual - Page 17
17
Delta 31-340 Instruction manual - Page 18
18
13
Fig. 31
Fig. 32
REMOVING AND
INSTALLING
ABRASIVE BELTS
1. DISCONNECT MACHINE FROM POWER SOURCE.
2. Unscrew and remove the two knobs (A) Fig. 31, and
remove the side cover (B) from the belt unit.
3. Press down on the tracking knob to release belt
tension and remove belt (C) Fig. 32, from the three
pulleys (D), as shown.
4. Install new 1" x 42" belt and replace side cover.
Check belt tracking by referring to the section
“TRACKING THE SANDING BELT,” and adjust if
necessary. IMPORTANT: Some belts have a directional
arrow printed on the inside of the belt. In these cases the
belt must be installed so the directional arrow is in the
same direction that the machine is running. The sanding
belt travels down at the front of the machine.
REMOVING AND
INSTALLING ABRASIVE
DISCS
1. DISCONNECT MACHINE FROM POWER SOURCE.
2. Remove the sanding disc table.
3. Remove the old abrasive disc by peeling it from the
sanding disc plate.
4. Clean the disc plate thoroughly.
5. Remove the backing from the new abrasive disc and
press the abrasive disc firmly onto the disc plate.
6. Replace the sanding disc table.
Fig. 33
Fig. 34
MITER GAGE
A miter gage (A) Fig. 33, is supplied with your sander and
can be used on the disc table, as shown, or on the belt
table. The miter gage can be set anywhere up to 45
degrees right or left by loosening lock knob (B), tilting
miter gage body (C) to the desired angle and tightening
lock knob (B).
DUST CHUTES
Two dust chutes are supplied with your belt and disc
sander and are equipped with 1-1/4 inch I.D. openings
that can easily be connected to a dust collection system.
Dust chute (A) Fig. 34, is for the belt unit and dust chute
(B) is for the disc unit.
B
A
A
D
D
C
C
A
B
A
B