Delta 31-340 Instruction Manual
Download Instruction manual of Delta 31-340 Sander for Free or View it Online on All-Guides.com.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
12
Fig. 27
The table can be tilted 45 degrees to the front, as shown
in Fig. 27, by loosening lock lever (B). Using a
combination square (E) check to see if the table is at 45
degrees to the belt and tighten lock lever (B).
WARNING: TO AVOID TRAPPING THE WORK OR
FINGERS BETWEEN THE TABLE AND SANDING
BELT, THE TABLE EDGE (C) SHOULD BE
POSITIONED A MAXIMUM OF 1/16 INCH FROM THE
SANDING BELT (D) WHEN THE TABLE IS TILTED.
DISC TABLE ADJUSTMENTS
The disc table (A) Fig. 28, can be tilted 45 degrees up or
down, by loosening lock handle (B), tilting the table, and
tightening lock handle (B). NOTE: The lock handle (B) is
spring-loaded and can be repositioned by pulling out the
handle (B) and repositioning it on the serrated locking
stud located directly underneath the handle.
WARNING: TO AVOID TRAPPING THE WORK OR
FINGERS BETWEEN THE TABLE AND SANDING
DISC, THE SANDING DISC (C) SHOULD BE
ADJUSTED SO IT IS A MAXIMUM OF 1/16 INCH
FROM EDGE OF TABLE (D). This can be accomplished
by moving the sanding disc in or out on the motor shaft.
To check and see if the table is at 90 degrees to the
sanding disc, place a square (E) Fig. 29, on the table with
one end of the square against the sanding disc, as
shown. If an adjustment is necessary, loosen lock lever
(B), move table until you are certain it is at 90 degrees to
the sanding disc and tighten lock lever (B).
Then loosen screw (F) Fig. 30, and adjust pointer (G) so
it points to the “0” degree mark on the table scale.
Fig. 28
Fig. 29
Fig. 30
E
D
C
E
B
G
F
B
D
C
A