Delta 31-280 Instruction Manual

Download Instruction manual of Delta 31-280 Sander for Free or View it Online on All-Guides.com.

Brand: Delta

Category: Sander

Type: Instruction manual for Delta 31-280

Pages: 16 (0.62 Mb)

Download Delta 31-280 Instruction manual

Delta 31-280 Instruction manual - Page 1
1
Delta 31-280 Instruction manual - Page 2
2
Delta 31-280 Instruction manual - Page 3
3
Delta 31-280 Instruction manual - Page 4
4
Delta 31-280 Instruction manual - Page 5
5
Delta 31-280 Instruction manual - Page 6
6
Delta 31-280 Instruction manual - Page 7
7
Delta 31-280 Instruction manual - Page 8
8
Delta 31-280 Instruction manual - Page 9
9
Delta 31-280 Instruction manual - Page 10
10
Delta 31-280 Instruction manual - Page 11
11
Delta 31-280 Instruction manual - Page 12
12
Delta 31-280 Instruction manual - Page 13
13
Delta 31-280 Instruction manual - Page 14
14
Delta 31-280 Instruction manual - Page 15
15
Delta 31-280 Instruction manual - Page 16
16
12
Fig. 31
Fig. 30
Fig. 32
TILTING THE DISC SANDER TABLE
The table (A) can be tilted 45 degrees up (Fig. 31), or 45 degrees down (Fig. 32), by loosening the lock handle (B), tilt-
ing the table (A), and tightening lock handle (B). The degree of tilt is determined by the scale (C) Fig. 32, and pointer
(D) Fig. 32. NOTE: When tilting the table down (Fig. 32), rotate the stop (D) Fig. 30 out of the way.
5. The stop (D) Fig. 30 ensures that the table can rapidly return 90 degrees to the disc after the table has been
tilted.
6. Adjust pointer, if necessary, using the wrench supplied with the tool.
Fig. 29
A
B
E
C
D
F
A
B
A
D
C
B
Fig. 33
Fig. 34
ADJUSTING DISC TABLE
MITER GAUGE SLOT
PARALLEL TO
SANDING DISC
1. DISCONNECT TOOL FROM POWER SOURCE.
2. With the table (A) Fig. 33 positioned 90 degrees to the
disc, place a square (B) in the miter gauge slot with the blade
of the square touching the sanding disc.
3. Use a pencil to mark the disc where the blade contacts
it. (Fig. 33).
4. Rotate the disc to the other end of the table. Use a square
to check the distance between the miter gauge slot and the
mark on the disc made in STEP 3 (Fig. 34).
5. To adjust, loosen the four screws (D) Fig. 34 that hold the
table to the trunnions. Adjust the table until the miter gauge
slot is parallel to the disc. Tighten the four screws (D). NOTE:
When making this adjustment, tighten the lock handle (B)
Fig. 32.
6. IMPORTANT: MAINTAIN A MAXIMUM DISTANCE OF
1/16" BETWEEN THE SANDING DISC AND THE TABLE.
B
A
D