Delta 31-120 Instruction Manual

Download Instruction manual of Delta 31-120 Sander for Free or View it Online on All-Guides.com.

Brand: Delta

Category: Sander

Type: Instruction manual for Delta 31-120

Pages: 12 (0.21 Mb)

Download Delta 31-120 Instruction manual

Delta 31-120 Instruction manual - Page 1
1
Delta 31-120 Instruction manual - Page 2
2
Delta 31-120 Instruction manual - Page 3
3
Delta 31-120 Instruction manual - Page 4
4
Delta 31-120 Instruction manual - Page 5
5
Delta 31-120 Instruction manual - Page 6
6
Delta 31-120 Instruction manual - Page 7
7
Delta 31-120 Instruction manual - Page 8
8
Delta 31-120 Instruction manual - Page 9
9
Delta 31-120 Instruction manual - Page 10
10
Delta 31-120 Instruction manual - Page 11
11
Delta 31-120 Instruction manual - Page 12
12
8
Fig. 13
Fig. 14
Fig. 15
Fig. 16
TILTING THE TABLE AND
ADJUSTING THE 45 DEGREE
POSITIVE STOPS
MAKE CERTAIN MACHINE IS DISCONNECTED
FROM POWER SOURCE BEFORE MAKING ADJUST-
MENTS.
The table can be tilted up to 45 degrees up or down. To
tilt the table down as shown in Fig. 14, loosen table lock
handles (A) Fig. 13, and pivot table until desired angle is
established. Then tighten table locking handles. To tilt
the table (X) up as shown in Fig. 17, loosen table lock
handles (A) Fig. 13, pivot 90 degree positive stop (B) Fig.
15, to the position shown, and tilt the table to the desired
angle. Then tighten table locking handles. NOTE: Table
locking handles (A) Fig. 13, are spring-loaded and can be
repositioned on the stud by pulling out the handle and
repositioning it on the nut. A scale (C) Fig. 15, and point-
er (D) are provided to indicate the degree of tilt.
WARNING: REGARDLESS OF WHICH POSITION
THE TABLE IS TILTED, THE TABLE EDGE (Z) FIG. 14,
MUST BE POSITIONED A MAXIMUM OF 1/16" FROM
THE ABRASIVE DISC AS SHOWN, TO AVOID TRAP-
PING THE WORK OR FINGERS BETWEEN THE
TABLE AND ABRASIVE DISC. FOR ADJUSTMENTS,
SEE SECTION “ADJUSTING MITER GAGE SLOT PAR-
ALLEL WITH THE ABRASIVE DISC”.
WARNING: WE SUGGEST THAT ALL BEVEL SAND-
ING APPLICATIONS BE PERFORMED WITH THE
TABLE TILTED DOWN AS SHOWN IN FIG. 14; HOW-
EVER, IF THERE IS A NEED TO TILT THE TABLE UP
AS SHOWN IN FIG. 17, THE WORKPIECE MUST BE
SECURELY FASTENED OR CLAMPED TO A FIXTURE
OR JIG TO PREVENT THE WORKPIECE FROM BEING
TORN FROM HANDS AND BECOMING TRAPPED
BETWEEN THE TABLE AND ABRASIVE DISC.
To check and adjust the 45 degree positive stops, pro-
ceed as follows:
MAKE CERTAIN MACHINE IS DISCONNECTED
FROM POWER SOURCE BEFORE MAKING ADJUST-
MENTS.
1. Loosen table locking handles, one of which is shown
at (A) Fig. 16, and tilt the table to the 45 degree down
position as shown in Fig. 16, and tighten table locking
handles. Place a square (E) Fig. 16, on the table and
against the disc and check to see if the disc is 45
degrees to the table surface. If an adjustment is neces-
sary, proceed as follows:
A
D
B
C
A
E
X
Z