Delta 31-080 Instruction Manual
Download Instruction manual of Delta 31-080 Sander for Free or View it Online on All-Guides.com.
1
2
3
4
5
6
7
8
9
10
11
12
11
Fig. 27
Fig. 28
MITER GAGE
A miter gauge (A) Fig. 27, is supplied with your sander
and can be used on the disc table. The miter gauge head
(A) can be set up to 45 degrees right or left by loosening
lock knob (B), moving miter gauge head to the desired
angle and tightening lock knob (B).
DUST CHUTES
Two dust chutes are supplied with your belt and disc
sander. Equipped with 1-1/2" I.D. openings, these can
easily be connected to a dust bag. Dust chute (A) Fig. 28,
is for the belt unit while (B) is for the disc unit.
A
B
A
B
ACCESSORIES
A complete line of accessories is available from your Delta Supplier, Porter-Cable • Delta Factory Service Centers,
and Delta Authorized Service Stations. Please visit our Web Site
www.deltamachinery.com for a catalog or
for the name of your nearest supplier.
WARNING: Since accessories other than those offered by Delta have not been tested
with this product, use of such accessories could be hazardous. For
safest operation, only
Delta recommended accessories should be used with this product.
Model 31-055 Accessory
Flexable Shaft with 3/16"
Capacity Keyless Chuck
The Delta Model 31-055 accessory flexable shaft can be
attached to the Delta Model 31-080 1" Belt / 5" Disc
sander for the purpose of performing various grinding,
polishing, and sanding operations.
1. DISCONNECT MACHINE FROM POWER SOURCE.
2. Tilt the disc table to the down position, (see the
section “DISC TABLE ADJUSTMENTS”).
3. Cutt a small hole in the center of the abrasive disc
to provide an entrance for the flexible shaft.
4. Insert the threaded end (A) of the flexable shaft into
the power take off shaft (B) as shown in Fig. 29, and
tighten securley with pin (C). Remove pin (C) once
flexabel shaft is attached securley to the power take off
shaft.
5. Insert an approved attachment into the keyless
chuck (D) on the flexable shaft and tighten securley.
6. The flexable shaft will rotate in unison with the belt /
disc sander, when power is applied to the belt / disc
sander.
Fig. 29
A
B
C
D