Dell PowerVault 201S Installation Manual
Download Installation manual of Dell PowerVault 200S Storage for Free or View it Online on All-Guides.com. This version of Dell PowerVault 200S Manual compatible with such list of devices, as: PowerVault 200S, PowerVault 201S, PowerVault 210S, PowerVault 211S
Brand: Dell
Category: Storage
Type: Installation manual
Model: Dell PowerVault 200S , Dell PowerVault 201S , Dell PowerVault 210S , Dell PowerVault 211S
Pages: 48 (3.15 Mb)
1-4 Dell PowerVault 20xS Storage Systems Enclosure Services Expander Module Installation
If you want to configure the enclosure services expander modules from a cluster
operation to a noncluster operation, perform the following procedure on each module:
1. Remove the enclosure services expander module.
See “Replacing the Enclosure Services Expander Module” found later in this
document where removing the module is described.
2. Locate the two-pin jumper labeled “FORCED JOINED JP8” on the enclosure
services expander module (see Figure 1-1).
3. Move the jumper plug to connect only one pin of the FORCED JOINED JP8
jumper.
4. Install the two enclosure services expander modules into the PowerVault 20
x
S
storage system.
See “Installing the Enclosure Services Expander Module” found later in this
document.
NOTE: HP OpenView Network Node Manager Special Edition (NNM SE) 1.4 With
Dell OpenManage HIP 3.4 contains the backplane configuration feature that is used
to configure the enclosure services expander module for cluster operation through
software. However, this feature does not function properly. This problem will be
addressed in a future release of HP OpenView NNM SE x.x With Dell OpenManage
HIP x.x.
cluster operation
(forced joined mode)
noncluster operation
(default configuration)
two-pin jumper
(FORCED JOINED JP8)