Dell PowerVault 3000i System Installation Manual
Download System installation manual of Dell PowerVault MD3000i Enclosure, Network Storage Server for Free or View it Online on All-Guides.com.
Brand: Dell
Category: Enclosure , Network Storage Server , Server , Software , Speaker System , Storage
Type: System installation manual
Model: Dell PowerVault MD3000i , Dell PowerVault 3000i
Pages: 68 (0.57 Mb)
Setting Up Your iSCSI Storage Array 53
discovery.sendtargets.auth.password = password_1
discovery.sendtargets.auth.username = iqn.1984-
05.com.dell:powervault.123456
discovery.sendtargets.auth.password_in = test1234567890
If you are using SLES10 SP1 via the GUI
1
Select
Desktop
→
YaST
→
iSCSI Initiator
.
2
Click
Service Start
, then select
When Booting
.
3
Select
Discovered Targets
, then select
Discovery
.
4
Enter the IP address of the port.
5
Click
Next
.
6
Select any target that is not logged in and click
Log in
.
7
Choose one:
• If you are not using CHAP authentication, select
No Authentication
. Proceed to step 8.
or
• If you are using CHAP authentication, enter the CHAP username and password. To enable
Mutual CHAP, select and enter the Mutual CHAP username and password.
8
Repeat step 7 for each target until at least one connection is logged in for each controller.
9
Go to
Connected Targets
.
10
Verify that the targets are connected and show a status of
true
.