304 Script Commands
Stop Configuration Database Diagnostic
This command stops the diagnostic test to validate the configuration
database in the controller firmware that was started by the start
storageArray configDbDiagnostic command.
Stop storageArray configDbDiagnostic
NOTE: The controller firmware returns a confirmation that the diagnostic test was
cancelled. In addition, the database configuration diagnostic test can be started
through the storage management software GUI but cannot be stopped through the
storage management software GUI. If you want to stop a running diagnostic test,
you must use the
stop storageArray configDbDiagnostic
Stop Disk Group Blink
This command turns off the indicator LED on the physical disk that was
turned on by the start diskGroup blink command.
stop diskGroup blink
Stop Enclosure Blink
This command turns off the indicator LED on the enclosure that was turned
on by the start enclosure blink command.
stop enclosure blink
book.book Page 304 Wednesday, June 8, 2011 12:20 PM