Script Commands 303
Start Storage Array iSCSI Refresh
This command initiates a refresh of the network address information for the
iSNS server. If the DHCP server is marginal or unresponsive, the refresh
operation can take from 2 to 3 minutes to complete.
NOTE: This command is for IPv4 only.
start storageArray isnsServerRefresh
NOTE: If you used the set storageArray isnsIPv4ConfigurationMethod command to
set the configuration but did not set the configuration to DHCP, running the start
storageArray isnsServerRefresh returns an error.
Start Virtual Disk Initialization
This command starts the formatting of a virtual disk in a storage array.
NOTE: Initializing a virtual disk is a long-running operation that you cannot stop.
start virtualDisk [virtualDiskName] initialize
virtualDisk Name of the virtual disk for which to start the formatting. You
must put brackets ([ ]) around the virtual disk name. If the
virtual disk name has special characters, you must also put
quotation marks (" ") around the virtual disk name.
book.book Page 303 Wednesday, June 8, 2011 12:20 PM