Script Commands 267
NOTE: When using this command, you can specify one or more of the parameters.
You do not, however, need to use all of the parameters.
NOTE: You can apply the
parameters to only one virtual disk at a time.
NOTE: Setting the
starts a long-running operation that you cannot stop. These long-running
operations are performed in the background and do not prevent you from running
other commands. To display the progress of long-running operations, use the show
virtualDisk actionProgress command.
accessVirtualDisk Specifies the logical unit number for the
access virtual disk. The logical unit number is
the only property that you can set for the access
NOTE: If you specify the
parameter, the only property that you can set is
logicalUnitNumber Defines specific virtual disk-to-LUN mappings
to an individual host or assigns the host to a
host Specifies the name of the host to which the
virtual disk is mapped. You must put
quotation marks (" ") around the host name.
hostGroup Specifies the name of the host group to which
the virtual disk is mapped. You must put
quotation marks (" ") around the host group
book.book Page 267 Wednesday, June 8, 2011 12:20 PM