Dell PowerVault MD3620f Command Line Interface Manual
Download Command line interface manual of Dell PowerVault MD3600f Desktop, Disk array system for Free or View it Online on All-Guides.com.
Brand: Dell
Category: Desktop , Disk array system , Software , Storage
Type: Command line interface manual
Model: Dell PowerVault MD3600f , Dell PowerVault MD3620f
Pages: 328 (6.84 Mb)
Download Dell PowerVault MD3600f Command line interface manual
Script Commands 145
single parameter or all of the parameters to meet your configuration
requirements. After entering the autoConfigure storageArray command, the
RAID controller modules set up the storage array using either the default
parameters or those you selected.
Syntax
autoConfigure storageArray
physicalDiskType=(SAS)
raidLevel=(0 | 1 | 5 | 6)
diskGroupWidth=numberOfPhysicalDisks
diskGroupCount=numberOfDiskGroups
virtualDisksPerGroupCount=
numberOfVirtualDisksPerGroup
hotSpareCount=numberOfHotSpares
segmentSize=segmentSizeValue
cacheReadPrefetch=(TRUE | FALSE)
securityType=(none | capable | enabled)]
Parameters
Parameter Description
physicalDiskType Type of physical disks to use for the storage array.
Valid physical disk type is Serial Attached SCSI
(SAS). This parameter is not required if only one
type of physical disk is in the storage array.
raidLevel RAID level of the disk group that contains the
physical disks in the storage array. Valid RAID
levels are 0, 1, 5 or 6.
diskGroupWidth Number of physical disks in a disk group in the
storage array. For information about the number
of physical disks that you can use in a disk group,
see "Enclosure Loss Protection" on page 54.
diskGroupCount Number of disk groups in the storage array. Use
integer values.
virtualDisksPerGrou
pCount
Number of equal-capacity virtual disks per disk
group. Use integer values.
book.book Page 145 Wednesday, June 8, 2011 12:20 PM