Dell PowerConnect M6348 Configuration Manual
Download Configuration manual of Dell PowerEdge M520 Computer Hardware, Desktop for Free or View it Online on All-Guides.com.
Brand: Dell
Category: Computer Hardware , Desktop , Network Hardware , Network Router , Server , Switch
Type: Configuration manual
Model: Dell PowerEdge M520 , Dell PowerEdge M820 Systems , Dell PowerConnect M6348
Pages: 158 (1.54 Mb)
Switching Configuration 25
3
Switching Configuration
This section provides configuration scenarios for the following features:
• "Virtual LANs" on page 25
• "IGMP Snooping" on page 32
• "IGMP Snooping Querier" on page 33
• "Link Aggregation/Port Channels" on page 35
• "Port Mirroring" on page 38
• "Port Security" on page 39
• "Link Layer Discovery Protocol" on page 40
• "Denial of Service Attack Protection" on page 42
• "DHCP Snooping" on page 44
• "Port Aggregator" on page 51
• "sFlow" on page 63
Virtual LANs
Adding Virtual LAN (VLAN) support to a Layer 2 switch offers some of the benefits of both bridging
and routing. Like a bridge, a VLAN switch forwards traffic based on the Layer 2 header, which is fast.
Like a router, it partitions the network into logical segments, which provides better administration,
security and management of multicast traffic.
A VLAN is a set of end stations and the switch ports that connect them. You can have many reasons
for the logical division, for example, department or project membership. The only physical
requirement is that the end station, and the port to which it is connected, both belong to the same
VLAN.
Each VLAN in a network has an associated VLAN ID, which appears in the IEEE 802.1Q tag in the
Layer 2 header of packets transmitted on a VLAN. An end station may omit the tag, or the VLAN
portion of the tag, in which case the first switch port to receive the packet may either reject it or
insert a tag using its default VLAN ID. A given port may handle traffic for more than one VLAN, but
it can only support one default VLAN ID.
Two features let you define packet filters that the switch uses as the matching criteria to determine if
a particular packet belongs to a particular VLAN: