Dell PowerEdge C8000 Owner's Manual
Download Hardware owner's manual of Dell PowerEdge C8000 Desktop, Server for Free or View it Online on All-Guides.com.
200 Installing System Components
Installing the Back GPGPU Card Assembly
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
CAUTION: Expansion cards can only be installed in the slots on the expansion
card riser. Do not attempt to install expansion cards directly into the riser
connector on the system board.
1
Connect the emergency throttling cable to the GPGPU card. See
Figure 3-49.
2
Holding the front GPGPU card assembly, position the card so that the card
edge connector aligns with the GPGPU card riser connector on the sled
cover. See Figure 3-48.
3
Insert the card edge connector firmly into the riser connector until the
card is fully seated.
4
Replace the four screws securing the back GPGPU card assembly to the
sled cover. See Figure 3-48.
5
Place the air baffle into the sled cover aligning the holes on the air baffle
with the screw holes on the sled cover. See Figure 3-47.
6
Replace the two screws securing the air baffle to the sled cover. See
Figure 3-47.
7
Connect the power cables to the GPGPU card. Press down on the locking
tab to secure the power cables. See Figure 3-46 cable routing diagram.
8
If necessary, route the cables and secure the cables to the retaining clips.
9
Place the filler panel into the sled cover. See Figure 3-40.
10
Replace the four screws securing the filler panel to the sled cover. See
Figure 3-40.
11
Close the sled. See "Installing the Sled Cover" on page 168.
12
Replace the sled. See "Installing a Sled" on page 142.