Dell PowerEdge 2300 Installation And Troubleshooting Manual
Download Installation and troubleshooting manual of Dell 2300 Desktop, Projector for Free or View it Online on All-Guides.com.
Brand: Dell
Category: Desktop , Projector , Server , Wireless Router
Type: Installation and troubleshooting manual for Dell 2300
Pages: 199 (4.58 Mb)
8-8 Dell PowerEdge 2300 Systems Installation and Troubleshooting Guide
3 HUIRUPLQJD0HPRU\8SJUDGH
Use the following procedure to perform a memory upgrade to the system board:
5HPRYHWKHULJKWVLGHFR PSXWHUFRYHU
See “Removing the Computer Covers” in Chapter 7.
&$87,216HH ´3URWHFWLQJ$JDLQVW(O H FWURVWDWLF'LVF K DUJHµLQWKHVDI HW\
LQVWUXFWLRQVDWWKHIURQWRIWKLVJXLGH
/RFDWHWK H ',00VRFNHWVL Q ZK LFK\RX ZLOOLQVWD OORUUHSODFH ' , 00V
Figure 8-1 shows the relative location of the DIMM sockets on the system board.
Figure 8-4 shows the labeling of the DIMMs sockets.
,QVWDOORUUHSODFHWKH',00VDVQHFHVVDU\WRUHDFKWKHGHVLUHGPHPRU\
WRWDO
Follow the instructions in “Installing DIMMs” or “Removing DIMMs” found later
in this section, as appropriate.
5HSODFHWKHULJKWVLGHFRPSXWHUFRYHUDQGWKHQUHFRQQHFWWKHFRP
SXWHUDQGSHULSKHUDOVWRWKHLU$&SRZHUVRXUFHVDQGWXUQWKHPRQ
After the system completes the power-on self-test (POST) routine, it runs a mem-
ory test that displays the new memory total, which includes all newly installed
memory.
NOTE: If the memory total is incorrect, turn off and disconnect the computer and
peripherals from their AC power sources, remove the right-side computer cover,
and check all the installed DIMMs to make sure they are seated properly in their
sockets. Then repeat step 4.
The system detects that the new memory does not match the system configura-
tion information, which is stored in nonvolatile random-access memory
(NVRAM). The monitor displays an error message that ends with the following
words:
Press <F1> to continue; <F2> to enter System Setup,
<CTRL><ALT><F10> to enter Utility Mode.
3UHVV)!WRHQWHUWKH6\VWHP6 HWXSSURJUDPDQGF KHFNWKH6\VWHP
0HPRU\VHWWLQJVLQWKHV\VWHPGDWDER [RQWKH6\VWHP6HWXSVFU HHQV
The system should have already changed the value in the System Memory set-
ting to reflect the newly installed memory. Verify the new total by adding the
Base Memory and Extended Memory values.
If the total is incorrect, one or more of the DIMMs may not be installed properly.
Repeat this procedure again, checking to make sure the DIMMs are firmly seated
in their sockets.
32268BK0.BK : 32268C80.FM Page 8 Monday, March 16, 1998 8:56 AM