PowerConnect M6220/M6348/8024/8024F/M8024/M8024-k/
7024/7048/7024P/7048P/7024F/7048R/7048R-RA Release Notes
System Firmware Version 4.1.0.6 Page 19
CDP (ISDP) is active on port-channels
instead of the member Ethernet
interfaces. For dynamic LAGS, the ISDP
information is not exchanged on the
interface until the port-channel becomes
active.
User confusion over switch
operations. Inability to interoperate
with other switches.
CDP is active on the member ports for
dynamic LAGs when the LAG is active.
User frustration over switch
configuration.
The CLI manual has an index
Script validation is fails when max SNTP
servers are configured.
User confusion over switch
configuration.
Corrected CLI validation check so that
existing server can be entered multiple
times.
Configured SYSLOG server parameters
cannot be updated without deleting and
re-configuring
User frustration over switch
configuration.
Syslog server parameter can be updated in
the CLI without deleting the server
CLI will not let user configure available
parameter for the given IGMP command
User frustration over switch
configuration.
IGMP configuration commands can be
entered in interface VLAN mode at any
time
Inconsistent behavior - using same port
number for multiple services
User confusion over switch
operations.
Attempting to add a service with a TCP
port overlapping a TCP port used by an
existing service is denied with an
appropriate error message.
LLDP Assignment of port ID for Port-
Description TLV
User confusion over switch
operations. Inability to diagnose
network issues.
The LLDP port id TLV is supported by
PowerConnect and can be displayed on
peer devices
Management ACL list needs "Match every
packet" option
User frustration over switch
configuration. Possible security
issue.
New syntax has been added to the
management ACL to allow the any
specification for the service type.
SNMP support for Dell-LAN-TRAP-MIB
User frustration over switch
configuration.
The Dell-LAN-TRAP-MIB is supported
