Airaid 310-164 Installation Instructions
Download Installation instructions of Airaid 310-164 Other for Free or View it Online on All-Guides.com.
1
2
Installation Instructions
Part Number 310-164
1997-2002 Jeep Wrangler (TJ)
2.5L I-4
1. Disconnect the negative battery cable.
Loosen the hose clamp that holds the factory
intake tube to the resonator.
2. Unlatch the clips on the factory air cleaner
lid, next remove the lid, and tube as an assem-
bly.
3. Loosen the clamp that holds the resonator to
the throttle body.
4. Disconnect the breather hose from the reso-
nator.
5. Remove the bolt that holds the resonator to
the valve cover.
6. Remove the resonator from the vehicle.
7. Remove three bolts from inside the lower air
cleaner box and remove it from the vehicle.
8. A.) On the right fender, pry two tabs away
from the fuse box, lift it up and set it off to the
side. B.) Next, remove and save the outside bolt
from the fuse box mount. It will be re-used in
step #14.
9. Remove one bolt from the passenger side
radiator fan shroud and save it for step #15.
Packing List:
#1 700-456 Airaid Premium Filter 1
#2 KIT158MAFC MAF Panel 1
#3 KIT158BPC Bottom Panel 1
#4 KIT164T Airaid Intake Tube 1
#5 KITHUMPHS09 Urethane Hump Hose 1
#6 KITRDCR03 Reducer 1
#7 KITWSTRIP02 Weather Strip 27” 1
KIT164HP Hardware & Instructions 1
#8
KIT6C31MXPPZ 6-32x5/16” Screw 4
#9 KIT6NWSAPZ #6 Flat Washer 4
#10 KIT6CNKEPZ 6-32 Keps Nut 4
#11 KIT15DHC3050 ¼ - 20x1/2” Button Head Bolt 2
#12 KIT09FWX019 ¼” Flat Washer 3
#13 KIT09FEZ025125 1/4” Fender Washer 1
#14 KIT25CNNES 1/4-20 Nylock Nut 1
#15 KIT60C120HCS M6x12mm Hex Bolt 1
#16 KITHS44 #44 Hose Clamp 2
#17 KITHS72 #72 Hose Clamp 2
#18 KIT164B L-Bracket 1
#19 KITGRMT05 Grommet 1
Tools Required For Installation:
5/32” Allen Wrench
5/16” & 7/16” Sockets
10mm & 13mm Sockets
Ratchet & Extension
Phillips Screwdriver
10. Remove and save the bolt from the pas-
senger side radiator support brace. It will be
re-used in step #13.
11. Assemble the two Cool Air Dam panels (#2)
& (#3) using the four 6-32 screws (#8), #6 flat
washers (#9), and nuts (#10), as shown.
12. Slide the rubber grommet (#19) over the
radiator support, followed by the assembled
CAD. Use caution not to scratch the paint on
the support rod.
A.
B.