GE WE25M46 Installation Instructions Manual

Download Installation instructions manual of GE Profile WE25M46 Laundry Accessories for Free or View it Online on All-Guides.com.

Brand: GE

Category: Laundry Accessories

Type: Installation instructions manual for GE Profile WE25M46

Pages: 12

Download GE Profile WE25M46 Installation instructions manual

GE Profile WE25M46 Installation instructions manual - Page 1
1
GE Profile WE25M46 Installation instructions manual - Page 2
2
GE Profile WE25M46 Installation instructions manual - Page 3
3
GE Profile WE25M46 Installation instructions manual - Page 4
4
GE Profile WE25M46 Installation instructions manual - Page 5
5
GE Profile WE25M46 Installation instructions manual - Page 6
6
GE Profile WE25M46 Installation instructions manual - Page 7
7
GE Profile WE25M46 Installation instructions manual - Page 8
8
GE Profile WE25M46 Installation instructions manual - Page 9
9
GE Profile WE25M46 Installation instructions manual - Page 10
10
GE Profile WE25M46 Installation instructions manual - Page 11
11
GE Profile WE25M46 Installation instructions manual - Page 12
12
REMOVE THE FRONT AND TOP
1. Disconnect gas inlet from the dryer. Unscrew gas
flexible connector or gas pipe line.
2. Remove the rotary knob by pulling straight out.
3. Remove the Phillips-head screw located inside
the control knob recess.
4. Raise the control panel vertically to disengage the
four key slots from the four grommets.
ENTER
STEAMREFRESH
SPEED DRY
WARM UP
ACTIVE WEAR
WRINKLE FREE
DELICATES
NORMAL /
MIXED LOADS
SENSOR DRY
TIME DRY
COTTONS
SPECIALTY
CYCLES
TIMED DRY
STEAM
DEWRINKLE
Remove
screw
06-11 GE Printed in Mexico
Installation Instructions
31-16671
BEFORE YOU BEGIN
Read these instructions completely and carefully.
This kit contains the necessary parts for conversion,
from Natural Gas to LP (Propane) Gas, of GE Dryer
models with “KIT M46” specified on the rating plate.
PARTS INCLUDED IN THE KIT
Gas Valve for LP (Propane) Gas
Instructions (English, French & Spanish)
Conversion Rating Plate (English/French/Spanish)
Responsibility Label (English/French/Spanish)
WARNING: This conversion kit shall be
installed by a qualified service agency in
accordance with the manufacturer’s instructions,
CAN/CGA-B149-1 and CAN/CGA-B149-2
installation codes and the requirements of the
authorities having jurisdiction. The information in
these instructions must be followed to minimize
the risk of fire or explosion or to prevent property
damage, personal injury or death. The qualified
service agency is responsible for the proper
installation of this kit. The installation is not proper
and complete until the operation of the converted
appliance is checked as specified in the
manufacturer’s instruction supplied with the kit.
GAS VALVE FOR LP (PROPANE) GAS
The valve is equipped with a nozzle #54 (1.4 mm
dia. (0.055 dia.) orifice and a pressure regulator set
at 22.35±0.7cm (8.8±0.3) of water column for an
output energy of 21,400 BTU/hr on LP (Propane) gas.
Required inlet pressure: minimum 22.89 cm (9.0”)
of water, maximum 35.5 cm (14.0”) of water.
For operation at elevation above 610 m (2,000
ft), input rating should be reduced at a rate of 4
percent for each 305 m (1,000 ft) above sea level.
IMPORTANT SAFETY NOTICE:
This information is intended for use by individuals
possessing adequate backgrounds of electrical,
electronic and mechanical experience. Any
attempt to repair a major appliance may result in
personal injury and property damage. Neither the
manufacturer nor the seller can be responsible for
the interpretation of this information or any liability in
connection with its use.
LP (PROPANE) GAS
CONVERSION KIT - WE25M46
STEP 1
1/8 NPT manifold
pressure tap Not
visible
Automatic valve
Dual Coil, 2nd
Stage
1st
Stage
Coil
Gas Pipe
Bracket
Burner
WARNING:
Before beginning the installation, turn off the
circuit breaker(s) or remove the dryer’s circuit
fuse(s) at the electrical box. Be sure the dryer cord
is unplugged from the wall.
Turn the dryer’s gas shutoff valve in the supply
line to the OFF position.
ENTER
STEAMREFRESH
SPEED DRY
WARM UP
ACTIVE WEAR
WRINKLE FREE
DELICATES
NORMAL /
MIXED LOADS
SENSOR DRY
TIME DRY
COTTONS
SPECIALTY
CYCLES
TIMED DRY
STEAM
DEWRINKLE
Pull knob
straight
out and
off
Lift and
remove
1