GE Lumination RC Series Installation Manual

Download Installation manual of GE LRC6 Lantern for Free or View it Online on All-Guides.com. This version of GE LRC6 Manual compatible with such list of devices, as: LRC6, LRXR6, LRXR8, RC8, RX8

GE LRC6 Installation manual - Page 1
1
GE LRC6 Installation manual - Page 2
2
GE LRC6 Installation manual - Page 3
3
GE LRC6 Installation manual - Page 4
4
GE LRC6 Installation manual - Page 5
5
GE LRC6 Installation manual - Page 6
6
GE LRC6 Installation manual - Page 7
7
1
RC/LRC/RX/LRX Series - New Construction Frame
Lumination
TM
LED Luminaire
Installation Guide
BEFORE YOU BEGIN
Read these instructions completely and carefully.
NOTICE
Lamp Housings RC6, RC8 or LRC6, LRC8 or RX6, RX8 or LRXR4, LRXR6, LRXR8 may be assembled with part FRAMExR. When Lamp Housings RC6,
RC8 or LRC6, LRC8 or RX6, RX8 or LRXR4, LRXR6, LRXR8 is assembled with Part FRAMExR the nal assembly complies with UL 1598 category IFAO
recessed luminaire requirements. LRX products are suitable for wet location covered ceiling only.
Les boîtiers de lampes RC6, RC8 ou LRC6, LRC8 ou RX6, RX8 ou LRXR4, LRXR6, LRXR8 peuvent être montés avec la pièce FRAMExR. Lorsque les
boîtiers des lampes RC6, RC8 ou LRC6, LRC8 ou RX6, RX8 ou LRXR4, LRXR6, LRXR8 sont montés avec la pièce FRAMExR, le montage nal respecte
les exigences des luminaires encastrés de la catégorie IFAO de la norme UL 1598. LRX produits conviennent pour emplacement humide couverte
au plafond uniquement.
Save These Instructions
Use only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer.
Prepare Electrical Wiring
Electrical Requirements
The LED luminaire must be connected to the mains
supply according to its ratings on the product label.
Grounding Instructions
The grounding and bonding of the overall system
shall be done in accordance to local electric code of
the country where the luminaire is installed.
WARNING/AVERTISSEMENT
RISK OF ELECTRIC SHOCK
• Turn power off before inspection, installation or removal.
• Properly ground electrical enclosure.
RISK OF FIRE
• Follow all NEC and local codes.
• Use only UL approved wire for input/output connections.
Minimum size 18 AWG or 14 AWG for continuous runs.
RISQUES DE DÉCHARGES ÉLECTRIQUES
• Coupez l’alimentation avant d’’inspecter, installer ou déplacer le luminaire.
• Assurez-vous de correctement mettre à la terre le boîtier d’alimentation électrique.
RISQUES D’INCENDIE
• Respectez tous les codes NEC et codes locaux.
• N’utilisez que des ls approuvés par UL pour les entrées/sorties de
connexion. Taille minimum 18 AWG ou 14 AWG pour les rangées continues.