• Home
• Brands
• Danby Manuals
• Danby DPAC10010
• Danby DPAC10010 Owner's Use And Care Manual

Danby DPAC10010 Owner's Use And Care Manual

Download Owner's use and care manual of Danby DPAC10010 Air Conditioner for Free or View it Online on All-Guides.com.

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

READ ALL SAFETY INFORMATION BEFORE USING

1) Check available power supply and resolve any wiring problems

BEFORE installation and operation of this unit. All wiring must

comply with local and national electrical codes and be installed by

a qualified electrician. If you have any questions regarding the

following instructions, contact a qualified electrician.

2) This appliance draws 7.8 nameplate amps under Cooling Mode

and may be used in any properly wired, general purpose 15 amp

household grounded receptacle.

3) For your safety and protection, this unit is grounded through the

power cord plug when plugged into a matching wall outlet. If you

are not sure whether the wall outlets in your home are properly

grounded, please consult a qualified electrician.

WARNING: Improper connection of the grounding plug can

result in risk of Fire, Electric Shock, and/or injury to Persons

associated with the appliance. Check with a qualified service

representative if in doubt that the appliance is proplery grounded.

4) DO NOT USE PLUG ADAPTERS OR EXTENSION CORDS

WITH THIS UNIT. If it is necessary to use an extension cord with

this unit, use an approved “air conditioner” extension cord only

(available at most local hardware stores).

5) To avoid the possibility of personal injury, always disconnect the

power supply to the unit before installing and/or servicing.

TABLE 1

Suggested Individual Branch Circuit

Nameplate Amps *AWG Wire Size

9.5 16

AWG- American Wire Gauge

*Based on copper wire at 60°C temperature rating.

TABLE 2

Receptacle and Fuse Types

Rated Volts 125

Amps 13

Wall Outlet

Fuse Size 15

Time Delay Fuse Plug Type

(or Circuit Breaker)

IMPORTANT SAFETY INFORMATION

ELECTRICAL

SPECIFICATIONS

CAUTION: Do not leave this unit

unattended in a space where people or

animals cannot react to a failed unit are

located. A failed unit can cause extreme

overheating or death in such an enclosed,

unattended space.

2

The power cord supplied with this air conditioner contains a device that senses damage to

the power cord. To test if your power cord is working properly, you must do the following:

1) Connect the power supply cord to an electrical

outlet.

2) The power supply cord has two buttons located on

the head of the plug. One button is marked

“TEST”, and the other is marked “RESET”. Press

the “TEST” button; you will hear a click as the

“RESET” button pops out.

3) Press the “RESET” button; you will hear a click

as the button engages.

4) The power supply cord is now energized and

supplying electricity to the air conditioner (on

some products this is also indicated by a light on

the plug head).

NOTE: The power cord supplied with this air

conditioner contains a current leakage detection

device designed to reduce the risk of fire. In the event

the power supply cord is damaged, it cannot be

repaired and must be replaced with a new cord from

the product manufacturer.

• Under no circumstances should this device be used

to turn the unit on or off.

• The “RESET” button must always be pushed in

(engaged) for correct operation.

• The power supply cord must be replaced if it fails to

reset when the “TEST” button is pushed in.

POWER

SUPPLY CORD