Samsung AllShare Cast Dongle User Manual

Download Operation & user’s manual of Samsung AllShare Cast Dongle Adapter, Computer Hardware for Free or View it Online on All-Guides.com.

Samsung AllShare Cast Dongle Operation & user’s manual - Page 1
1
Samsung AllShare Cast Dongle Operation & user’s manual - Page 2
2
- 1 - - 2 -
AllShare Cast Dongle
GH68-37002W
Type C. 05/2013. Rev. 1.3
ENGLISH
Safety Precautions
Keep your device dry
Humidity and all types of liquids may damage device
parts of electronic circuits.
Do not use or store your device in dusty, dirty
areas
Dust can cause your device to malfunction.
Avoid exposing your device to very cold or very
hot temperatures (below 5 °C or above 35 °C)
Extreme temperatures can cause the deformation of
the device and reduce the charging capacity and life
of your device.
Do not drop your device or cause impacts to
your device
If bent or deformed, your device may be damaged or
parts may malfunction.
Do not disassemble, modify, or repair your device
Any changes or modifications to your device can void
your manufacturer’s warranty. For service, take your
device to a Samsung Service Centre.
When cleaning your device:
Wipe your device with a towel or an eraser. Do not use
chemicals or detergents.
Do not use the device for anything other than its
intended use
Avoid using your device’s light close to the eyes of
children or animals
Use only Samsung-approved adapters
Unauthorised or Non-Samsung chargers could cause
damage to your device or in extreme circumstances
an explosion, it could also invalidate any warranty on
the product.
Using the AllShare Cast Dongle
You can view your mobile devices screen on a monitor.
Use the mobile device supporting the AllShare Cast or Screen Mirroring feature, and the monitor
supporting HDMI(High Definition Multimedia Interface) feature and HDCP(High-bandwidth Digital
Content Protection) feature. Some devices may not be compatible.
Graphics used in this manual are for illustration purposes. The actual products may vary.
Overview
1
HDMI socket
2
Power socket
3
Reset button
4
Status indicator
Make sure you have the following items:
AllShare Cast Dongle, travel adapter, HDMI A-to-A
cable, and user manual. The supplied items
may vary.
Make sure the AllShare Cast Dongle is connected to a mains outlet.•
AllShare Cast Dongle supports monitors up to 1080p. The supported resolution may differ •
depending on the connected mobile device.
When an error occurs while in use, disconnect the travel adapter and connect again.•
AllShare Cast• or Screen Mirroring automatically terminates when a headset or a Bluetooth
headset is connected to the mobile device during video playback. However, it stays connected
when playing games or using the Internet.
PIN code method (complete steps within 30 seconds)•
On the mobile device, launch AllShare Cast or Screen Mirroring. The monitor displays the AllShare
Cast Dongle's name. Tap and hold the same name from the list that is displayed on your mobile
device. Check the PIN code displayed on the monitor, and enter the PIN code on your mobile device.
To connect to a previously used device (complete steps within 2 minutes):
3-2
On the mobile device, launch AllShare Cast or Screen Mirroring. The monitor displays the AllShare
Cast Dongle's name. Select the same name from the list that is displayed on your mobile device.
When the connection is complete, the monitor displays the mobile device's home screen.
4
The screen aspect ratio on your device should be identical with that of the monitor. Otherwise, part •
of displayed screen may be cut off. For better picture quality, set the screen aspect ratio on your
monitor to fit its original screen or select the auto aspect ratio setting manually. If auto aspect ratio
setting is not available on your device, some parts of screen can be cut off.
To connect to a new device, press and hold the Reset button until the indicator turns red, and then
5
release. Repeat this setup procedure from step 3.
Connect the AllShare Cast Dongle to a mains outlet using the travel adapter. The indicator turns
1
red after 3 to 4 seconds.
Connect the AllShare Cast Dongle to a monitor using the HDMI A-to-A cable.
2
The red indicator begins blinking after approximately 30 seconds.
For information about connecting the HDMI cable, refer to the monitor’s user manual.•
The mobile device cannot connect to the AllShare Cast Dongle, unless the AllShare Cast Dongle is •
connected to a monitor.
To connect to a new mobile device, use one of the following methods. The PIN code method is not
3-1
supported on some mobile devices.
Reset button method (complete steps within 2 minutes)•
Press the Reset button. The indicator turns blue. On the mobile device, launch AllShare Cast or
Screen Mirroring. The monitor displays the AllShare Cast Dongle's name. Select the same name
from the list that is displayed on your mobile device.
简体中文
安全注意事项
保持设备干
湿气和所有类型的液体都可能损坏电路的设备
部件。
请勿在多尘、脏污的地方使用或存放设备
灰尘可能导致设备故障。
请勿将设备置于温度过低或过高
( 5˚C 以下或 35˚C ) 环境下
极端的温度会导致设备变形、降低设备的充电容
量,并缩短设备的使用寿命。
请勿让设备坠落或受到撞击
如果设备弯曲或变形,可能会导致设备损坏或
部件故障。
请勿拆卸、改造或修理设备
如果对设备有任何改动或修改,制造商的担保将
会失效。 设备需要维修时,请联系 Samsung
务中心。
在清洁设备时:
用毛巾或擦除器擦拭设备 切勿使用化学品或
清洁剂。
请勿将设备用于既定用途以外的任何用途
请避免靠近儿童或动物的眼睛使用设备指示灯
仅可使用 Samsung 认可的充电
未获授权或者非 Samsung 认可的充电器可能会
坏设备,在极端情况下甚至引起爆炸,同时也可能
使本产品的任何担保失效
本手册中的图形用于说明。 可能与真实产品的外观有所不同。
概览
1
HDMI 插口
2
电源插口
3
重置按钮
4
状态指示灯
确保您有以下项目: 乐共享投射转接器、旅
行充电器、HDMI A-to-A 数据线和用户手册。
提供的物品可能有所不同
使用娱乐共享投射转接器
在显示器上可以查看移动设备的屏幕。
使用支持 AllShare Cast Screen Mirroring 功能的移动设备,以及支 HDMI(高分辨率多媒体
界面)功能 HDCP(高带宽数字内容保护)功能的显示器。 某些设备可能不兼容。
使用旅行充电器将娱乐共享投射转接器连接到电源插座。 示灯将在 3 4 秒后
1
变为红色。
使用 HDMI A-to-A 数据线将娱乐共享投射转接器连接到显示器。
2
大约 30 秒后,红色指示灯开始闪烁。
有关连接 HDMI 据线的信息,请参阅显示器的用户手册。
除非娱乐共享投射转接器已连接到显示器,否则移动设备无法连接到娱乐共享投射转接器。
要连接到新的移动设备,请使用下列方法之一。 有些移动设备不支持
3-1
PIN 码方法。
重置按钮方法(2 分钟内完成所有步骤)
按下重置按钮。 指示灯将变为蓝色。 在移动设备上启动 AllShare Cast Screen Mirroring
显示器会显示娱乐共享投射转接器的名称。 从移动设备所显示的列表中选择同一名称。
PIN 方法(30 秒内完成所有步骤)
移动设备上启动 AllShare Cast Screen Mirroring 示器会显示娱乐共享投射转接器的
名称。 移动设备所显示的列表中点住同一名称。 检查显示器上显示的 PIN 码,然后在移
动设备上输 PIN 码。
要连接到之前用过的设备(2 分钟内完成所有步骤):
3-2
在移动设备上启动 AllShare Cast Screen Mirroring 显示器会显示娱乐共享投射转接器的
名称。 移动设备所显示的列表中选择同一名称。
连接完成后,显示器将显示移动设备的主屏幕。
4
设备的屏幕宽高比应与显示器的相同。 否则,部分显示的画面可能会被切掉。 为提高图像质
量,请将显示器的屏幕宽高比设置为适应其原始屏幕,或者手动选择自动宽高比设置。 如果
自动宽高比设置在您的设备上不可用,部分画面可能会被切掉。