Beam IridiTRAK RST430 Quick Start Manual

Download Quick start manual of Beam IridiTRAK RST430 Monitor, Recording Equipment for Free or View it Online on All-Guides.com.

Beam IridiTRAK RST430 Quick start manual - Page 1
1
Beam IridiTRAK RST430 Quick start manual - Page 2
2
Beam IridiTRAK RST430 Quick start manual - Page 3
3
Beam IridiTRAK RST430 Quick start manual - Page 4
4
IridiTRAK RST430
ALERT / TRACKING / MONITORING INTERFACE
Quick
Start
Guide
A
P
B
KJIHGFEC L ONM D
ITEM CONNECTOR DESCRIPTION 430 410
A Iridium Antenna TNC Antenna connector for Iridium 9601 SBD module (Internal Transceiver Module)
B GPS Antenna SMA Antenna connector for super-sense GPS module
C Status LED Dual Colour Network Registration / GPS / Status LED
D Cong port USB Programming & conguration port
E I/O Connector 10 Pins 10 pins - Input & Output pluggable connector
F Pin 1 Screw Terminal Power V– (GND)
G Pin 2 Screw Terminal Power V+ (+Vin)
H Pin 3 Screw Terminal Master On/Off Input. If not using, Wire-link to +Vin to remain ON
I Pin 4 Screw Terminal Ignition Sense Input. Use to determine when to Sleep. If not using, Wire-link to +Vin to remain awake.
J Pin 5 Screw Terminal Loop A In NORMALLY CLOSED loop, connect to an alert button / pendant system relay contacts.
If not using, it MUST be wire-linked CLOSED to avoid false emergency
K Pin 6 Screw Terminal Loop A Out
L Pin 7 Screw Terminal Loop B In NORMALLY CLOSED loop, connect to an alert button / pendant system relay contacts.
If not using, it MUST be wire-linked CLOSED to avoid false emergency
M Pin 8 Screw Terminal Loop B Out
N Pin 9 Screw Terminal Alert LED Out
O Pin 10 Screw Terminal Spare GND (normally used for Alert LED)
P Mounting Holes 4mm Mounting holes for securing terminal
Device Port DB9 Male Device Port for RS232 communications to an external Transceiver module
Thank you for purchasing BEAM IridiTRAK
This Quick Start Guide lists 4 steps to install and
congure your BEAM IridiTRAK:
1) Connecting power loom
2) Connecting antennas
3) Powering up
4) Conguring IridiTRAK & testing
Package Contents
Before you start, make sure you have all required
components:
RST430 IridiTRAK Unit
Power Cable Loom
USB Conguration Cable
Installation & User Manual
Resource CD-ROM
Quick Start Guide
CAUTION
Before you install and operate your
IridiTRAK, refer to the safety instructions in
the Installation & User Manual”
!