• Home
• Brands
• andrews Manuals
• andrews ET 21
• Andrews ET 21 Operating Instructions & Safety Manual

Andrews ET 21 Operating Instructions & Safety Manual

Download Operating instructions & safety manual of andrews ET 21 Air Conditioner for Free or View it Online on All-Guides.com.

1

2

3

Click www.andrews-sykes.com

or Call Us Free 0800 211 611

ET 21 & 25

Portable Air Conditioning

Operating Instructions

& Safety Guide

General Safety

Keep children and animals away from air conditioning units. Never

leave them alone in a room where the units in use.

This equipment should only be used by a competent person who

has read and understood these instructions.

Never operate this equipment if you are ill, feeling tired or under the

influence of alcohol or drugs.

Keep the Air Conditioning vents clear of all obstructions.

Never put anything on top of the unit or block the air outlets.

Make sure equipment is switched off and unplugged after use.

Never leave switched on or unattended.

Do not use the unit where sunlight is shining directly onto it.

Check condition of equipment before use. If unit is showing signs

of damage contact your supplier immediately.

Use a 230V. 50HZ. 1 phase power supply only. (Wrong supply may cause a

fire and / or shock hazard.)

Securely plug into an earthed supply. (Unless earthed, may cause electric shock)

Do not use a damaged power cable, plug or socket. (Short, fire or shock hazard)

Do not remove plug by pulling cable or with wet hands. (Risk of fire and

electric shock)

Before cleaning, remove plug from socket. (Otherwise risk of electric shock)

Do not place anything on top of the machine. (This may cause electric shock,

malfunction or injury)

Do not use an extension lead unless of the approved type. Fully uncoil extension

leads when being used. (Heavy duty, risk of fire and / or electric shock.)

Ensure mains plug is clean and securely plugged in. (Otherwise it may short

causing smoke and fire)

Ensure correct 13 amp fuse is fitted in the plug. (Otherwise malfunction or fire

may result)

Do not ‘kink’ or sharply bend the power cable nor put weight on it. (The

installation may be damaged causing fire and / or electric shock)

Do not turn off by removing power plug. Always turn off at control panel first.

(Risk of electric shock and / or malfunction)

Do not use this cooler on unstable or inclined surfaces. Always use on solid flat

floor. (Risk of falling causing injury, fire or malfunction)

• Ensure the safety of the location in which cooler is to be used.

• Ensure the oor or ground is smooth and sound.

• Ensure you allow at least 50cm air space all around the cooler.

• When in position LOCK the casters to prevent rolling.

• Never use the cooler at more than 2º incline.

Do not place cooler on uneven, unstable or inclined surface. (This could cause

malfunction)

When storing the cooler, ensure that it is kept in a dry, cool place. (To prevent

corrosion and malfunction)

If not being used for some time or lighting is present, always unplug from

mains. (To prevent risk of electric shock, short circuit or fire)

Do not spray water on to the cooler nor use solvents such as benzene, thinner

or alcohol for cleaning. (There is a risk of electric shock and / or short circuit)

If the power cable is damaged this must be replaced by a fully qualified

electrician. (To avoid danger of electric shock, short circuit or fire.

Cleaning Maintenance

1. To remove filters, slide up a little and

pull towards you .

2. Clean the filters with water or compressed air.

3. Clean evaporator and condenser units

with a vacuum cleaner or compressed air.

1. After cleaning, completely

dry the inside of the unit by

operating on 'Fan Mode'

only 3 to 4 hours.

2. Turn 'OFF' at control panel,

remove plug from socket.

Coil and store cable neatly.

3. Keep machine suitably

covered to prevent damage

by damp, humidity and dust.