ADVANCED Network Devices IPSWS Installation Instructions

Download Installation instructions of ADVANCED Network Devices IPSWS Speakers for Free or View it Online on All-Guides.com.

ADVANCED Network Devices IPSWS Installation instructions - Page 1
1
ADVANCED Network Devices IPSWS Installation instructions - Page 2
2
IPSWS
Installation Instructions
Version 1.4
For additional support, visit www.anetdsupport.com
The following instructions should be followed for IPSWS installations:
A ferrite is included if there is concern over line performance. Wrap Cat 5 cable around ferrite once
and clamp shut.
Surface Mount Install (uses IPS-SM2 surface mount rear enclosure)
1. Remove device from packaging.
2. Remove all four Phillips screws from front baffle.
3. Remove front baffle from rear enclosure taking care not to damage the control board and set
baffle and screws aside.
4. If running conduit or wiremold to the enclosure, break open the top or bottom wiremold
knockout on the enclosure as desired.
5. Place enclosure on wall surface, centered over Ethernet cable access if not running cable along the
exterior wall, and mark the desired hole pattern to be drilled using the holes provided in the
enclosure surface back.
6. Set enclosure aside and drill pilot holes for anchors or screws to be used on mounting surface.
7. Install anchors (not provided) if used.
8. Place enclosure on wall surface over the pilot holes or anchors and thread screws (not provided)
into wall. Tighten securely.
9. If using wiremold, complete the Ethernet cable run to the enclosure.
10. Complete any additional wiring for accessories, then connect the Ethernet cable to Ethernet jack
J3 on the circuit board. (see Figure A)
11. Place front baffle assembly over the enclosure and thread the four provided screws through the
baffle and into the enclosure at the four corners of the baffle. Tighten securely.
Flush Mount Install (uses IPS-FM2 flush mount rear enclosure)
1. Remove rear enclosure, IPS-FM2, from packaging.
2. If wall surfaces are already installed, place enclosure on wall surface adjacent to a stud and trace
the perimeter of the enclosure. Cut a hole in the wall along the traced perimeter.
3. Break open the appropriate knockout for the conduit or cable run.
4. Place one side of enclosure on a stud and mark desired pilot holes within the 3 slots provided.
5. Set enclosure aside and drill pilot holes for the screws to be used on the mounting surface.
6. Place enclosure on the stud over the pilot holes and thread screws
(not provided) into the stud. Tighten securely.
7. Complete the Ethernet cable run into the enclosure.
8. Remove front baffle assembly, IPSWS, from packaging.
9. Remove bag of screws from rear speaker magnet.
10. Complete any additional wiring for accessories, then connect the
Ethernet cable to Ethernet jack J3 on the circuit board. (see Figure A)
11. Place front baffle assembly over the enclosure taking care not to
damage the control board and thread the four provided screws through
the baffle and into the enclosure at the four corners of the baffle.
Tighten securely. Figure A