Franke CM 85 M Installation And Operating Instructions Manual
Download Installation and operating instructions manual of Franke CM 981 M Oven for Free or View it Online on All-Guides.com. This version of Franke CM 981 M Manual compatible with such list of devices, as: CM 981 M, CR 82 M, CS 82 M, SM 82 M, TL 981 M
Brand: Franke
Category: Oven
Type: Installation and operating instructions manual
Model: Franke CM 981 M , Franke CR 82 M , Franke CS 82 M , Franke SM 82 M , Franke TL 981 M
Pages: 138
Download Franke CM 981 M Installation and operating instructions manual
19
End of cooking timer knob
The end of cooking timer is a practical device that turns the oven off automatically at a
set time in an interval of 1 to 120 minutes. To use the end of cooking timer, the ringer
must be wound up by turning the knob (B) almost one full turn clockwise; then, turning
back, set the required time by aligning the number corresponding to the minutes with
the fixed reference on the front panel. At the end of the set time, the ringer sounds and
the oven is automatically switched off.
N.B.: The oven stays hot at around the set cooking temperature for a long time after it
has been switched off; therefore to avoid overcooking or burning the food, it is advisable
to remove it from the oven.
N.B.: To use the oven in manual mode, i.e. without using the end of cooking
timer, align the knob pointer with the fixed symbol on the front panel.
When the oven is turned off, the end of cooking programmer can be used as a
normal timer.
End of cooking clock
This clock is already set for manual oven use, therefore cooking is possible even without
adjusting it.
Right knob
Press the right knob to select in sequence the functions to be activated (timer, end of
cooking, cooking start, time setting), signalled by the respective LED blinking.
Press this knob briefly to check already programmed settings (Query), or press it for
about 2 seconds to cancel settings (Reset).
Left knob
Turn the left knob to set the hands of the time clock relevant to the activated function
(LED blinking).
LEDs
– blinking: ready for setting or signalling end of function (together with the ringer)
– lit: function running
Timer ( )
To set the timer, press the knob on the right once (the corresponding LED
begins to blink); then turn the knob on the left to move the hands in order
to set the timer duration. Press the right knob again to confirm the setting;
the corresponding LED changes from blinking to steady. The hands will
then return to their original position to indicate the current time: when the
set time is reached, the ringer sounds. This sound can be stopped by
pressing the right knob.
The timer does not control oven heating.
End of cooking ( )
To set the end of cooking time, press the right knob twice (the LED for the symbol begins to flash); then turn the
knob on the left to move the hands in order to set the end of cooking time.
The LED will blink for the next 10 seconds (for possible adjustments), after which the setting will be acquired and the
LED becomes steady.
The same effect is obtained by pressing the right knob twice during blinking.
At the end of cooking, oven heating will be deactivated and the ringer will sound for 1 minute; this sound can be stopped
by pressing the right knob.
N.B.: At the end of cooking, the oven remains at a temperature close to the previously set value for several minutes;
it is therefore wise to remove the food from inside so as to avoid overcooking it.
B
I
V
I
I
V
I
I
IX
V
V
I
VI
I
I
I
I
X
X
I
I
I
I
X
I
TIMER
START
STOP
B
B