Ecom Instruments Ex-Handy 05 Safety Instructions

Download Safety instructions of Ecom Instruments Ex-Handy 05 Cell Phone for Free or View it Online on All-Guides.com.

Ecom Instruments Ex-Handy 05 Safety instructions - Page 1
1
Ecom Instruments Ex-Handy 05 Safety instructions - Page 2
2
Ecom Instruments Ex-Handy 05 Safety instructions - Page 3
3
Ecom Instruments Ex-Handy 05 Safety instructions - Page 4
4
Ecom Instruments Ex-Handy 05 Safety instructions - Page 5
5
Ecom Instruments Ex-Handy 05 Safety instructions - Page 6
6
Ecom Instruments Ex-Handy 05 Safety instructions - Page 7
7
Ecom Instruments Ex-Handy 05 Safety instructions - Page 8
8
Ecom Instruments Ex-Handy 05 Safety instructions - Page 9
9
Ecom Instruments Ex-Handy 05 Safety instructions - Page 10
10
Ecom Instruments Ex-Handy 05 Safety instructions - Page 11
11
Ecom Instruments Ex-Handy 05 Safety instructions - Page 12
12
Ecom Instruments Ex-Handy 05 Safety instructions - Page 13
13
Ecom Instruments Ex-Handy 05 Safety instructions - Page 14
14
Ecom Instruments Ex-Handy 05 Safety instructions - Page 15
15
22
SAR: GSM 900: 0.219 W/kg
DCS 1800: 0.021 W/kg
Permissible maximum value for both frequencies:
2,000 W/kg
7. Battery
7.1 Changing the battery
The battery module Ex-AMH 05 of the Ex-Handy 05 may only be changed outside
the Ex-area. Only those battery modules which are approved by the manufacturer
may be used. Other battery modules may not be taken into the Ex-area.
Removing the battery module
Proceed as follows to remove the rear cover (when replacing the battery):
- Remove the 6 screws using the screwdriver provided and then extract the
battery module from the phone.
- When changing the battery module the battery compartment and the circulating
seal are to be examined for any contamination and cleaned, if necessary, with a
brush or by using blasts of compressed air.
- Insert the new battery module into the phone.
- Secure the battery module in place with the 6 screws, using the prescribed
torque (0.15 Nm).
- Dispose of the battery module in accordance with local regulations.
7.2 Charging the battery
Your phone is supplied with power via a rechargeable battery. Before a new batte-
ry can be used for the first time it must be charged for at least 4 hours. Full battery
performance is only obtained after a few operating cycles. If the battery charge
level decreases below the operating value, this will be indicated by the phone (the
empty battery symbol flashes). When this appears charge the battery for at least
15 minutes before making any other calls, in order to prevent your discussion
from being interrupted.