Crestron TSW-552 Do Manual

Download Do manual of Crestron TSW-550 Touch Panel, Touchscreen for Free or View it Online on All-Guides.com.

Crestron TSW-550 Do manual - Page 1
1
Crestron TSW-550 Do manual - Page 2
2
DO GUIDE
DO Check the Box
QTY PART NUM.
1 TSW-UMB Universal Mounting Bracket 4517962
1 Pre-Construction Bracket 2035648
TSW-552
5" Touch Screen
DO Install the Device
The TSW-552 can be mounted into drywall and other surfaces
or mounted onto a wall stud. When mounted into drywall and
other surfaces, the touch screen protrudes just 1/2” (13 mm)
from the mounting surface.
To mount the TSW-552, use the following procedure:
1. For pre-construction applications, use standard drywall
nails or screws to attach the included pre-construction
bracket to a wall stud.
Pre-Construction Bracket Attached to a Wall Stud
CAUTION: Allow an air gap of at least 12” (305 mm) in
the wall cavity above and below the TSW-552 for heat
dissipation.
For post-construction applications, use the
pre-construction bracket as a cutout template by turning
the bracket to face the wall, ensuring it is level, and
temporarily tacking it to the wall with nishing nails (not
included) in the smaller holes around the cutout opening.
Trace the cutout opening with an appropriate drywall saw
(not included).
Post-Construction Installation of the TSW-UMB Universal Mounting
Bracket into a Cutout
2. Loosen the two screws on the included TSW-UMB
Universal Mounting Bracket, and then install the
TSW-UMB bottom rst into the opening.
Installing the TSW-UMB
3. Reach into the TSW-UMB and push the rear half back
to ensure it is fully behind the mounting surface. Ensure
the front of the TSW-UMB is level. Then, tighten the two
screws to complete the installation.
CAUTION: To avoid damage to the bracket, do not
overtighten the screws.
Completing the TSW-UMB Installation
4. Make connections to the TSW-552 using Crestron
®
power supplies and Crestron equipment. Power and
data connection to the TSW-552 is provided by a single
Ethernet cable connected to the LAN port at the rear of
the unit. A Crestron PoE power supply or PoE-capable
network switch is recommended (both sold separately).
Apply power after the Ethernet cable is connected.
Hardware Connections for the TSW-552
5. Carefully hold the touch screen over the TSW-UMB and
gently place it in position. The magnets on the rear of the
touch screen hold it in place on the TSW-UMB.
Pre-Construction Bracket
Use a tie wrap to hold the cable
until the TSW-552 is mounted.
TSW-UMB
Push the top surface
downward to install
the bottom half rst.
TSW-UMB
Loosen both of the screws.
Push the rear half back.
Ensure the front is level.
Then, tighten both screws.
Reset Button
LAN PoE:
10BASE-T /
100BASE-TX
Ethernet to LAN