Asus RP-AC56 Quick Start Manual
Download Quick start manual of Asus RP-AC56 Extender, Network Router for Free or View it Online on All-Guides.com.
1
2
Quick Start Guide
RP-AC56
Wireless-AC1200 Range Extender
Q10397
First Edition
April 2015
1. Power LED
On: RP-AC56 is on
2. 5 GHz Wi-Fi LED
Green: RP-AC56 provides excellent Wi-Fi
extender performance.
Orange: RP-AC56 provides acceptable Wi-Fi
extender performance.
Red: RP-AC56 provides poor Wi-Fi extender
performance.
: RP-AC56 is not connected to a router/AP.
3. 2.4 GHz LED
Green: RP-AC56 provides excellent extender
performance.
Orange: RP-AC56 provides acceptable Wi-Fi
extender performance.
Red: RP-AC56 provides poor Wi-Fi extender
performance.
: RP-AC56 is not connected to a router/AP.
Quick Setup with WPS (Wi-Fi Protected Setup)
For router/Access Point(AP) with WPS support
Power On
Place your RP-AC56 near your router/AP and plug it
to a power outlet.
Wait until the power LED
turns solid green.
Connect via WPS (Wi-Fi Protected Setup)
1. Press the WPS button on your
Router/AP.
2. Press the WPS button on your RP-AC56 for
more than two (2) seconds until the LEDs
start to blink.
NOTE: Ensure that your router/AP supports WPS. Otherwise, use Method TWO.
about two (2) minutes and
then turns solid green. The
color of the LED indicates
the Wi-Fi signal strength.
3
Place in an ideal location
After placing your RP-AC56 in an ideal location, RP-AC56 connects to your router/AP in about one (1) minute.
NOTES:
• Place your RP-AC56 between your router/AP
and wireless device to get the best extender
performance.
• Place your RP-AC56 in a location where you can
get green or orange Wi-Fi LED.
IMPORTANT!
• To minimize interference, keep RP-AC56 away from devices like cordless phones, Bluetooth devices and microwave ovens.
• We recommend that you place your RP-AC56 in open or spacious location.
Enjoy!
1 2
Frequently Asked Questions (FAQ)
Q1: What should I do if my router does not support WPS?
A1: You can use Method Two to set up RP-AC56.
Q3: Why is it that I cannot see the login page after entering
http://repeater.asus.com in the browser?
A3: Ensure that your computer is connected to the extender network only,
and set your computer to Obtain an IP address automatically.
Q2: Why is that the Wi-Fi LED does not light up after completing Method
Two?
A2: You may have entered the wrong router SSID and password. Reset your RP-AC56,
double check your router SSID/password, and set up RP-AC56 again.
Q4: How do I reset RP-AC56?
A4: Press the RESET button on the front cover of RP-AC56 for about two (2)
Method One
Your RP-AC56’s wireless network name (SSID) chang-
es to your existing Wi-Fi network name, ending with
_RPT or _RPT5G and shares your router/AP’s Wireless
Password.
Q10397_RP-AC56_QSG_Special.indd 1 2015/6/10 17:31:34