Maytag ACM1580AB Service Manual
Download Service manual of Maytag ACM1580AB Microwave Oven for Free or View it Online on All-Guides.com. This version of Maytag ACM1580AB Manual compatible with such list of devices, as: ACM1580AB, ACM1580AS, JMC9158AAB, JMC9158AAQ, JMC9158AAW
Brand: Maytag
Category: Microwave Oven
Type: Service manual
Model: Maytag ACM1580AB , Maytag ACM1580AC , Maytag ACM1580AS , Maytag ACM1580AW , Maytag JMC9158AAB , Maytag JMC9158AAQ , Maytag JMC9158AAS , Maytag JMC9158AAW
Pages: 34
16026267 18 ©2005 Maytag Services
Disassembly Procedures
To avoid risk of electrical shock, personal injury or death;
disconnect power to oven and discharge capacitor before
following any disassembly procedures.
WARNING
!
Outer Case Removal
1. Remove screws securing outer case to chassis.
2. Push outer case approximately 1 inch to the back of
the unit, which will free case from front plate.
3. Lift outer case from chassis.
4. Reverse procedures to reinstall.
Control Panel Assembly and Printed Circuit
Board Removal
1. Remove outer case, see “Outer Case Removal”
procedure.
2. Disconnect wire leads from printed circuit board.
3. Remove screw securing ground wire to membrane
key pad.
4. Remove screws securing front control panel to
chassis.
5. Slide control panel upward to release plastic tabs.
6. Remove screws securing printed circuit board to
control panel.
7. Replace and reassemble in reverse order.
Key pad
Control
panel
Printed
circuit
board
Door Removal
1. Disconnect power to oven.
2. Open the oven door, remove choke cover cap, and
slowly raise the door evenly. This disengages the
pins located at the top and bottom.
NOTE: When aligning the door for assembly, the door
must be opened as much as possible.
3. To place door back on unit, place bottom pin into slot
first and then align the top pin. Once pins are aligned
push door downward to lock into place.
4. Replace choke cover cap to complete assembly.
NOTE: After replacing door, verify monitor, primary, and
secondary switches are operating properly.
NOTE: Perform radiation leakage test to verify door is
securely seated.
Door Disassembly
1. Remove door, see “Door Removal” procedure.
2. Pry chock cover off door frame assembly.
3. Remove and replace damaged piece.
4. Reassembly in reverse order.
5. Perform microwave leakage test.