Samsung CK95 Service Manual

Download Service manual of Samsung CK95 Microwave Oven for Free or View it Online on All-Guides.com. This version of Samsung CK95 Manual compatible with such list of devices, as: CK95, CK96T, CK97B, CK98F

Samsung CK95 Service manual - Page 1
1
Samsung CK95 Service manual - Page 2
2
Samsung CK95 Service manual - Page 3
3
Samsung CK95 Service manual - Page 4
4
Samsung CK95 Service manual - Page 5
5
Samsung CK95 Service manual - Page 6
6
Samsung CK95 Service manual - Page 7
7
Samsung CK95 Service manual - Page 8
8
Samsung CK95 Service manual - Page 9
9
Samsung CK95 Service manual - Page 10
10
Samsung CK95 Service manual - Page 11
11
Samsung CK95 Service manual - Page 12
12
Samsung CK95 Service manual - Page 13
13
Samsung CK95 Service manual - Page 14
14
Samsung CK95 Service manual - Page 15
15
Samsung CK95 Service manual - Page 16
16
Samsung CK95 Service manual - Page 17
17
Samsung CK95 Service manual - Page 18
18
Samsung CK95 Service manual - Page 19
19
Samsung CK95 Service manual - Page 20
20
Samsung CK95 Service manual - Page 21
21
Samsung CK95 Service manual - Page 22
22
Samsung CK95 Service manual - Page 23
23
Samsung CK95 Service manual - Page 24
24
Samsung CK95 Service manual - Page 25
25
Samsung Electronics 4-3
Disassembly and Reassembly
1. Disconnect the oven from the power source.
2. Remove the 10A fuse in the Noise filter.
3. When replacing the 10A fuse, be sure to use an
exact replacement part. If new 10A fuse blows
out again after replacement, check the primary
interlock switch, door sensing switch and
interlock monitor switch.
4. When the above three switches operate properly,
check if any other part such as the control circuit
board, blower motor or high voltage
transformer is defective.
1. Take out the glass tray and guide roller from the
cavity.
2.
Turn the oven upside down to replace the drive motor.
3. Remove a screw securing the drive motor cover.
4. Disconnect all the lead wires from the drive motor.
5. Remove screws securing the drive motor to the
cavity.
6. Remove the drive motor and coupler.
7. When replacing the drive motor, be sure to
remount it in the correct position with the
coupler.
8. Connect all the leads to the drive motor.
9. Screw the drive motor cover to the base plate
with a screw driver.
4-4 Replacement of Fuse
4-5 Replacement of Drive Motor
Screw
Drive Motor Cover Base Plate
Drive Motor
4-3-6 Reassembly Test
After replacement of the defective component parts of the door, reassemble it and follow the instructions below for proper
installation and adjustment so as to prevent an excessive microwave leakage.
1. When mounting the door to the oven, be sure to adjust the door parallel to the bottom line of the oven face
plate by moving the upper hinge and lower hinge in the direction necessary for proper alignment.
2. Adjust so that the door has no play between the inner door surface and oven front surface. If the door
assembly is not mounted properly, microwave energy may leak from the space between the door and
oven.
3. Do the microwave leakage test.