Philips ELI-S-20 Installation Instructions
Download Installation instructions of Philips ELI-S-20 Inverter for Free or View it Online on All-Guides.com.
1
2
3
4
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. To prevent high voltage from being present on the orange/black and yellow/black output leads prior to
installation, inverter connector must be open. Join inverter connector after the backup micro inverter has been
installed and before the AC power is supplied.
2. For use with fluorescent, incandescent or LED fixtures up to 20 W (0°C to 50°C including driver/ballast) at unity
power factor for UL and CSA. This product is also rated up to 25 W (0°C to 45°C including driver/ballast) at
unity power factor for UL only.
3. Make sure all connections are in accordance with the National Electrical Code or Canadian Electrical Code and
any local regulations.
4. To reduce the risk of electric shock, disconnect both normal and auxiliary power supplies and inverter connector
of the backup micro inverter before servicing.
5. This backup micro inverter is for factory or field installation.
6. An AC power source (120, or 277 VAC, 60 Hz) ahead of any wall switch is required to provide battery charging current.
7. Do not install near gas or electric heaters.
8. This product is for use with indoor or damp locations where ambient temperature is 0°C to 50°C. Not suitable
for wet or hazardous locations.
9. This is a sealed unit. Integral battery is not replaceable. Replace entire unit when necessary.
10. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
11. Do not use this product for other than intended use.
12. Servicing should be performed by qualified service personnel.
13. Equipment should be mounted in locations and at heights where it will not be subjected to tampering by
unauthorized personnel.
! IMPORTANT SAFEGUARDS !
WHEN USING ELECTRICAL EQUIPMENT, BASIC
SAFETY PRECAUTIONS SHOULD ALWAYS BE
FOLLOWED, INCLUDING THE FOLLOWING:
SAVE THESE INSTRUCTIONS
© Philips Emergency Lighting
A Division of Philips Electronics North America Corporation
236 Mt. Pleasant Rd. • Collierville, TN USA 38017-2752 • Tech Support 888-263-4638 • Fax 901-854-1630 • www.philips.com/bodine
70100901
UNIVERSAL INPUT, SINE WAVE OUTPUT,
ELI SERIES EMERGENCY LIGHTING EQUIPMENT INVERTER SINUSODIAL
ELI-S-20
THIS PRODUCT CONTAINS A RECHARGEABLE NICKEL-CADMIUM BATTERY.
THE BATTERY MUST BE RECYCLED OR DISPOSED OF PROPERLY.
INSTALLATION INSTRUCTIONS
11/09/12
Installation Instructions
NRTL/C
20 OR 25 W BACKUP MICRO INVERTER