Kenmore 767. 8703000 Service Manual

Download Service manual of Kenmore 767. 8703000 Microwave Oven for Free or View it Online on All-Guides.com. This version of Kenmore 767. 8703000 Manual compatible with such list of devices, as: 767. 8703000, 767. 8803000, 767. 8903000, 767. 8903400, 767. 8903900

Kenmore 767. 8703000 Service manual - Page 1
1
Kenmore 767. 8703000 Service manual - Page 2
2
Kenmore 767. 8703000 Service manual - Page 3
3
Kenmore 767. 8703000 Service manual - Page 4
4
Kenmore 767. 8703000 Service manual - Page 5
5
Kenmore 767. 8703000 Service manual - Page 6
6
Kenmore 767. 8703000 Service manual - Page 7
7
Kenmore 767. 8703000 Service manual - Page 8
8
Kenmore 767. 8703000 Service manual - Page 9
9
Kenmore 767. 8703000 Service manual - Page 10
10
Kenmore 767. 8703000 Service manual - Page 11
11
Kenmore 767. 8703000 Service manual - Page 12
12
Kenmore 767. 8703000 Service manual - Page 13
13
Kenmore 767. 8703000 Service manual - Page 14
14
Kenmore 767. 8703000 Service manual - Page 15
15
Kenmore 767. 8703000 Service manual - Page 16
16
Kenmore 767. 8703000 Service manual - Page 17
17
Kenmore 767. 8703000 Service manual - Page 18
18
Kenmore 767. 8703000 Service manual - Page 19
19
Kenmore 767. 8703000 Service manual - Page 20
20
Kenmore 767. 8703000 Service manual - Page 21
21
Kenmore 767. 8703000 Service manual - Page 22
22
Kenmore 767. 8703000 Service manual - Page 23
23
Kenmore 767. 8703000 Service manual - Page 24
24
Kenmore 767. 8703000 Service manual - Page 25
25
Kenmore 767. 8703000 Service manual - Page 26
26
Kenmore 767. 8703000 Service manual - Page 27
27
Kenmore 767. 8703000 Service manual - Page 28
28
Kenmore 767. 8703000 Service manual - Page 29
29
Kenmore 767. 8703000 Service manual - Page 30
30
Kenmore 767. 8703000 Service manual - Page 31
31
Kenmore 767. 8703000 Service manual - Page 32
32
Kenmore 767. 8703000 Service manual - Page 33
33
Kenmore 767. 8703000 Service manual - Page 34
34
Kenmore 767. 8703000 Service manual - Page 35
35
CAUTIONS
• Be sure to check microwave leakage prior to
servicing the oven if the oven is operative prior to
servicing.
• The service personnel should inform the
manufacture importer, or assembler of any
certified oven unit found to have a microwave
emission level in excess of 5 mW/cm
2
and should
repair any unit found to have excessive emission levels
at no cost to the owner and should ascertain the cause
of the excessive leakage. The service personnel
should instruct the owner not to use the unit until the
oven has been brought into compliance.
• If the oven operates with the door open, the service
personnel should:
- Tell the user not to operate the oven.
- Contact the manufacturer.
• The service personnel should check all surface and
vent openings for microwave leakage.
• Check for microwave leakage after every servicing.
The power density of the microwave radiation leakage
emitted by the microwave oven should not exceed
4 mW/cm
2
. Always start measuring of an unknown field
to assure safety for operating personnel from radiation
leakage.
MEASURING MICROWAVE ENERGY
LEAKAGE
• Pour 275±15cc of 20±5°C(68±9°F) water in a beaker
which is graduated to 600 cc, and place the beaker
on the center of the turntable.
• Set the energy leakage monitor to 2,450 MHz and
use it following the manufacturer's recommended
test procedure to assure correct result.
• When measuring the leakage, always use the 2-
inch (5cm) spacer supplied with the probe.
• Operate the oven at its maximum output.
• Measure the microwave radiation using and
electromagnetic radiation monitor by holding the
probe perpendicular to the surface being measured
Move probe along shaded area
Probe scanning speed
Less than 2.5 cm/sec
( 1in/sec)
5-1
SERVICE INFORMATION
TOOLS AND MEASURING INSTRUMENTS
MICROWAVE LEAKAGE TEST
NECESSARY TOOLS
Tools normally used for TV servicing are sufficient.
Standard tools are listed below.
• Diagonal pliers
• Long nose pliers
• Phillips screwdriver
• Flat blade screwdriver
• Wrench (size 5mm)
• Nutdriver (size 5mm)
• Adjustable wrench
• Soldering iron
• Solder
• Vinyl insulation tape
• Polishing cloth
NECESSARY MEASURING INSTRUMENTS
• TESTER (VOLTS-DC, AC, Ohmmeter)
• Microwave survey meter
- Holaday HI-1500
HI-1501
- Narda 8100
8200
• Inch scale
• 600 cc non conductive material beaker (glass or plastic),
inside diameter: approx. 8.5 cm (3
1
/2 in.)
• Cylindrical and made of borosilicate glass vessel.
max. thickness: 3 mm
outside diameter: approx. 190mm
height: approx. 90mm
• Glass thermometer: 100°C or 212°F (1 deg scale)