Maytag UMC1071AAB/W Service Manual
Download Service manual of Maytag AMC4080AAB/W/Q/S Microwave Oven for Free or View it Online on All-Guides.com. This version of Maytag AMC4080AAB/W/Q/S Manual compatible with such list of devices, as: AMC4080AAB/W/Q/S, AMC5101AAB/W/Q/S, MMC5080AAB/W/Q/S, MMC5193AAB/W/Q/S, UMC1071AAB/W
Brand: Maytag
Category: Microwave Oven
Type: Service manual
Model: Maytag AMC4080AAB/W/Q/S , Maytag AMC5101AAB/W/Q/S , Maytag AMC5143AAB/W/Q/S , Maytag MMC5080AAB/W/Q/S , Maytag MMC5193AAB/W/Q/S , Maytag UMC1071AAB/W
Pages: 53
Disassembly Procedures
To avoid the risk of electrical shock, personal injury or
death; disconnect power to oven and discharge
capacitors before following any disassembly procedure.
24 16022923 Rev. 0 ©2004 Maytag Services
WARNING
!
Gas/Humidity Sensor – MMC5080AA*,
AMC5143AA*and MMC5193AA*
The sensor is a plug-in device located on the cavity shell
near the rear of the unit.
1. Disconnect power to unit and remove outer case,
see "Outer Case" procedure.
2. Remove sensor retainer.
3. Disconnect wire terminal retaining plug.
4. Remove/replace sensor.
5. Reassemble in reverse order.
Sensor
Receptacle
Sensor
Retainer
Front of
Unit
Exact location
may vary
Oven Thermostat
The oven thermostat is located on the top left side of the
oven cavity on models AMC5143AA* and MMC5193AA*,
top right side of the oven cavity on all other models.
Thermostat is a resettable thermostat.
1. Disconnect power to unit and remove outer case,
see "Outer Case" procedure.
2. Disconnect wires.
3. Remove screw securing oven thermostat, slide
thermostat out.
4. Reassemble in reverse order.
Light Socket
1. Disconnect power to unit and remove outer case,
see "Outer Case" procedure.
2. Disconnect wire terminal plug from light socket.
3. Remove light socket from air duct by pressing
together the hold-downs located on the light socket
bracket.
4. Remove light bulb.
5. Replace and reassemble in reverse order.
Lamp
Wave Guide
Turntable Motor
1. Disconnect power to oven.
2. Open the oven door, remove turntable, and gently pry
upward on turntable shaft cover. During reassembly,
locate the half-moon design on the cover, align with
the shaft and genlty apply pressure.
3. Remove bottom plate cover by cutting metal tabs.
When reinstalling use the provided screw.
4. Disconnect wire leads from turntable motor.
Wire leads
Turntable motor
5. Remove screws securing turntable to the oven cavity.
6. Replace and reassemble in reverse order.