Pioneer DEH-P3000IB Installation Manual

Download Installation manual of Pioneer DEH-P3000IB Car Amplifier, Car Receiver for Free or View it Online on All-Guides.com.

Pioneer DEH-P3000IB Installation manual - Page 1
1
Pioneer DEH-P3000IB Installation manual - Page 2
2
Pioneer DEH-P3000IB Installation manual - Page 3
3
Pioneer DEH-P3000IB Installation manual - Page 4
4
Pioneer DEH-P3000IB Installation manual - Page 5
5
Pioneer DEH-P3000IB Installation manual - Page 6
6
Pioneer DEH-P3000IB Installation manual - Page 7
7
INSTALLATION MANUAL
INSTALLATION MANUAL
DEH-P3000IB
<KOKNX> <07H00000>
Printed in China
<CRD4249-A/S> ES
Installation English Installation English
Note
Check all connections and systems before final
installation.
Do not use unauthorized parts. The use of
unauthorized parts may cause malfunctions.
Consult with your dealer if installation requires
drilling of holes or other modifications of the
vehicle.
Do not install this unit where:
it may interfere with operation of the vehicle.
it may cause injury to a passenger as a result
of a sudden stop.
The semiconductor laser will be damaged if it
overheats. Install this unit away from hot places
such as near the heater outlet.
Optimum performance is obtained when the unit is
installed at an angle of less than 60°.
60°
• When installing, to ensure proper heat dispersal
when using this unit, make sure you leave ample
space behind the rear panel and wrap any loose
cables so they are not blocking the vents.
DIN Front/Rear-mount
This unit can be properly installed either from
"Front" (conventional DIN Front-mount) or
"Rear" (DIN Rear-mount installation, utilizing
threaded screw holes at the sides of unit
chassis). For details, refer to the following
installation methods.
DIN Front-mount
Installation with the rubber bush
1. Insert the mounting sleeve into the
dashboard.
• When installing in a shallow space, use a
supplied mounting sleeve. If there is enough
space behind the unit, use factory supplied
mounting sleeve.
2. Secure the mounting sleeve by
using a screwdriver to bend the
metal tabs (90°) into place.
3. Install the unit as illustrated.
53
53
1
1
182182
Removing the Unit
1.
Extend top and bottom of the trim
ring outwards to remove the trim
ring. When reattaching the trim ring,
push the trim ring onto the unit until
it clicks. (If the trim ring is attached
upside down, the trim ring will not
fit properly.)
• It becomes easy to remove the trim ring if the
front panel is released.
2. Insert the supplied extraction keys
into both sides of the unit until
they click into place.
3. Pull the unit out of the dashboard.
DIN Rear-mount
1.
Extend top and bottom of the trim
ring outwards to remove the trim
ring. When reattaching the trim ring,
push the trim ring onto the unit until
it clicks. (If the trim ring is attached
upside down, the trim ring will not
fit properly.)
• It becomes easy to remove the trim ring if the
front panel is released.
2. Determine the appropriate position
where the holes on the bracket and
the side of the unit match.
3. Tighten two screws on each side.
• Use either truss screws (5 mm × 8 mm)
or flush surface screws (5 mm × 9 mm),
depending on the shape of screw holes in the
bracket.
Dashboard
Mounting sleeve
Rubber bush
Screw
Trim ring
Trim ring
Dashboard or Console
Factory radio mounting bracket
Screw
CRD4249AS_inst.indd 1-4CRD4249AS_inst.indd 1-4 2007/08/24 10:42:362007/08/24 10:42:36