• Home
• Brands
• Pioneer Manuals
• Pioneer DEH-11
• Pioneer DEH-2100 Installation Manual

Pioneer DEH-2100 Installation Manual

Download Installation manual of Pioneer DEH-11 Car Receiver, Tuner for Free or View it Online on All-Guides.com. This version of Pioneer DEH-11 Manual compatible with such list of devices, as: DEH-11, DEH-1100, DEH-21 DEH-11, DEH-2100

1

2

3

4

5

6

Note:

• This unit is for vehicles with a 12-volt battery

and negative grounding. Before installing it in a

recreational vehicle, truck, or bus, check the bat-

tery voltage.

• To avoid shorts in the electrical system, be sure

to disconnect the ≠ battery cable before begin-

ning installation.

• Refer to the owner’s manual for details on con-

necting the power amp and other units, then

make connections correctly.

• Secure the wiring with cable clamps or adhesive

tape. To protect the wiring, wrap adhesive tape

around them where they lie against metal parts.

• Route and secure all wiring so it cannot touch

any moving parts, such as the gear shift, hand-

brake and seat rails. Do not route wiring in

places that get hot, such as near the heater outlet.

If the insulation of the wiring melts or gets torn,

there is a danger of the wiring short-circuiting to

the vehicle body.

• Don’t pass the yellow lead through a hole into

the engine compartment to connect to the battery.

This will damage the lead insulation and cause a

very dangerous short.

• Do not shorten any leads. If you do, the protec-

tion circuit may fail to work when it should.

• Never feed power to other equipment by cutting

the insulation of the power supply lead of the

unit and tapping into the lead. The current capac-

ity of the lead will be exceeded, causing over-

heating.

• When replacing fuse, be sure to use only fuse of

the rating prescribed on this unit.

• Since a unique BPTL circuit is employed, never

wire so the speaker leads are directly grounded

or the left and right ≠ speaker leads are com-

mon.

• Speakers connected to this unit must be high-

power types with minimum rating of 40 W

(45 W)* and impedance of 4 to 8 ohms.

Connecting speakers with output and/or imped-

ance values other than those noted here may

result in the speakers catching fire, emitting

smoke, or becoming damaged.

* DEH-2100 and DEH-21

• When this product’s source is switched ON, a

control signal is output through the blue/white

lead. Connect to an external power amp’s system

remote control or the car’s Auto-antenna relay

control terminal. (Max. 300 mA 12 V DC.) If the

car features a glass antenna, connect to the anten-

na booster power supply terminal.

• When an external power amp is being used with

this system, be sure not to connect the blue/white

lead to the amp’s power terminal. Likewise, do

not connect the blue/white lead to the power ter-

minal of the auto-antenna. Such connection could

cause excessive current drain and malfunction.

• To avoid short-circuiting, cover the disconnected

lead with insulating tape. Especially, insulate the

unused speaker leads without fail. There is a pos-

sibility of short-circuiting if the leads are not

insulated.

• If this unit is installed in a vehicle that does not

have an ACC (accessory) position on the ignition

switch, the red lead of the unit should be con-

nected to a terminal coupled with ignition switch

ON/OFF operations. If this is not done, the vehi-

cle battery may be drained when you are away

from the vehicle for several hours.

• The black lead is ground. Please ground this lead

separately from the ground of high-current prod-

ucts such as power amps.

If you ground the products together and the

ground becomes detached, there is a risk of dam-

age to the products or fire.

• Cords for this product and those for other prod-

ucts may be different colors even if they have the

same function. When connecting this product to

another product, refer to the supplied Installation

manuals of both products and connect cords that

have the same function.

No ACC positionACC position

O

N

S

T

A

R

T

O

F

F

A

C

C

O

N

S

T

A

R

T

O

F

F

+

≠

+

≠

≠

++

≠

≠

++

≠

Connecting the Units

INSTALLATION MANUAL

MANUEL D’INSTALLATION

<ENGLISH>

Connection Diagram

DEH-2100

DEH-1100

DEH-21

DEH-11

<99K00T0T01>

Printed in U.S.A.

Imprimé aux Etats-Unis

<HRD0147-A> UC

This product conforms to CEMA cord colors.

Le code de couleur des câbles utilisé pour ce produit

est conforme à CEMA.

Los colores de los cables este producto se conforman

con el código de colores CEMA.

This Product

Rear output

Antenna jack

Fuse

Black (ground)

Red

Yellow

To terminal always supplied with power

regardless of ignition switch position.

To electric terminal controlled by ignition

switch (12 V DC) ON/OFF.

To vehicle (metal) body.

With a 2 speaker system, do not connect

anything to the speaker leads that are not

connected to speakers.

Perform these connections when using a different amp (sold separately).

To system control terminal of

the power amp or Auto-antenna

relay control terminal.

(Max. 300 mA 12 V DC.)

Connecting cords with RCA

pin plugs (sold separately)

Blue/white

System remote control

Power amp

(sold separately)

White

White/black

Green

Green/black

Gray

Gray/black

Violet

Violet/black

Front

speaker

Rear

speaker

Right

Rear

speaker

Rear

speaker

Front

speaker

Rear

speaker

Left

Fuse holder