HP MSM710 Quick Start Manual
Download Quick start manual of HP MSM710 Controller, Recording Equipment for Free or View it Online on All-Guides.com.
Brand: HP
Category: Controller , Recording Equipment
Type: Quick start manual for HP MSM710
Pages: 6
1
2
3
4
5
6
In
MSM710 Controller Quickstart
This Quickstart applies to both the MSM710 Access Controller (J9328A) and the MSM710 Mobility Controller (J9325A).
This Quickstart introduces the HP ProCurve Networking MSM710 Controller and shows you how to get started using it. After following the directions in this
Quickstart, see the MSM7xx Controllers Management and Configuration Guide available at: www.hp.com/go/procurve/manuals.
Hardware overview
Package contents
MSM710, documentation, power supply, self-adhesive rubber feet.
LAN port and Internet port
The MSM710 has auto-sensing 10/100/1000 Ethernet ports, each with a corresponding
status light on the front panel. The LAN port supports Power over Ethernet (PoE) 802.3af,
enabling the MSM710 to be powered by a PoE switch or PoE power injector.
Reset button
Press and quickly release the button to reset the MSM710. This button can also be used to
reset the MSM710 to factory defaults. See Resetting to factory defaults in the MSM7xx
Controllers Management and Configuration Guide.
Console port
The MSM710 console port is a standard serial port with DB-9 connector. To connect to a
computer, use a standard (straight-through) serial cable (male-to-female). For pin-out
details, see the MSM7xx Controllers Management and Configuration Guide.
MSM710 front panel MSM710 rear panel