Asus RP-AC68U Quick Installation Manual
Download Quick installation manual of Asus RP-AC68U Extender, Repeater for Free or View it Online on All-Guides.com.
1
2
3
4
Quick
Installation
Guide
A quick look
Five LAN Gigabit ports
USB 3.0 port x 1
WPS button x 1
Power on off button x 1
Wi-Fi LED:
2.4G LED / 5G LED:
Three LEDs on: RP-AC68U has good signal
connection with router.
Two LEDs on: RP-AC68U has normal
signal connection with router.
One LEDs on: RP-AC68U has weak signal
connection with router.
Off: RP-N12 doesn’t connect to a router.
Plug your RP-AC68U into a
power outlet Near your
Router/AP
Method One
Quick Setup using the WPS Button
Use this if your Router or Access Point(AP) support WPS
Power On
Push the two WPS buttons
Push the WPS button on your
Router/AP
Immediately push the WPS
button on your RP-AC68U
The Stylish LED should go to
flashing in about 2 minutes.
Wait until the Wi-Fi LED turn
on. You could know the
signal quality with different
LED number.
Relocate RP-AC68U to a location you like.
After the extender is relocated to a new place, RP-AC68U will reconnect to your router automatically in about one minute.
The ideal location for RP-AC68U is between your wireless
router and wireless device.
Make sure RP-AC68U is in a location where signals
indictor LED has over 2 led on at least.
Keep the RP-AC68U away from devices like cordless
phones, Bluetooth devices and microwave ovens to
minimize wireless interference.
If possible, try to place your extender in open
corridors or spacious locations rather than a
crowded room.
Enjoy!
The Range Extender shares your router’s Wireless Network Name (SSID) and
Wireless Password
Frequently Asked Questions (FAQ)
Q1: What should I do if my router doesn’t have a WPS button?
A1: You can use Method Two to set up RP-AC68U
Q2 Why is that the Wi-Fi LED does not light up after completing Method Two?
A1: You may have entered the wrong router SSID and password. Reset your RP-AC56,
double check your router SSID/password, and set up RP-AC56 again.
Q3 How do I reset RP-AC68U
A1: Press the RESET button on the button of RP-AC68U for about two (2)
seconds. Wait for about five (5) seconds until the LEDs blink slowly.
RP-AC68U
Dual band Wireless Ranger Extender
Reset button